2016 FORD F-150 — Problems, Recalls & Safety Data

The first sign of trouble with my 2016 Ford F-150 was that the blind spot sensor failure light came on while driving. Then the engine warning light came on and the gear indicator on the dash went blank. Also, while the truck was in forward driving motion, it lost throttle control. After stopping the truck and shutting it off, it would not restart. The check engine codes were 0706 and 0707. After clearing these codes, the truck started again, but repeated the same issues three more times in one week. The truck was taken to the Ford dealership and confirmed that the lead frame needs to be replaced.

Vehicle is having ECM module errors and sensor issues just like other Ford models. It throws a code and then will not go above 5th gear or go below 3rd gear until vehicle is shut off and restarted. Once it restarts it is fine for a bit. It can go a few days in between malfunctions or can happen multiple times per day.

Had issue with sudden downshifting ,not changing gears ,hard shift as well. Took the vehicle to AAMCO and was told the transmission needed to be rebuilt. So i did just, at 99,000 miles. Not sure if this helps your findings.

Truck down shifts randomly, causes a shutter, and has a hard time accelerating. I had a sensor replaced inside of my transmission along with new transmission fluid put in and it failed to fix my problem.

I was driving down the road with the cruise set at 60 mph when I came over the top of a hill and I started to decend down the hill if felt like my truck had down shifted and the back tires locked up and screeched a little bit then a big bang happened and had no more drive gear as I hit the gas it just reved the motor up and didn’t move. Upon further inspection I pulled the rear differential cover off and my spider gears and the shaft holding the gears in place was snapped in 2 different places, chips in the gears. My transfer case chain was snapped in half and my transmission had hard shift from first to second gear and a loud buzzing noise. . I took the truck to my mechanic and hooked a scanner up to it and took it for a test run. As it was driving a sensor was telling the truck to shift into park as it was shifting from first to second or second to third causing a hard shift and buzzing noise and eventually losing all connectivity to the transmission and internals as well. I have sense replaced the whole rear axel, transfer case myself with used parts and is currently in the shop swapping transmissions as I needed my vehicle to continue working. Safety of myself and or others was definitely at risk when my rear tires locked up the rear end could have slid out cause me to wreck and possibly wreck into someone else. There was also no warning lights or anything on my dash before this incident occurred.