2010 RAM 1500 — Problems, Recalls & Safety Data

During unrelated work, a mechanic discovered the retaining ring for recall N08 (rear axle pinion nut) was not installed and the pinion nut was loose enough to turn by hand. He stated the recall had either been performed incorrectly or not at all, and that the vehicle was unsafe to drive. The recall shows “completed” in 2013, but the defect is still present. I contacted Stellantis Customer Care, submitted photos, and they confirmed in writing that if the defect still exists, the recall must be performed free of charge regardless of age, mileage, or ownership. I sent the photos of the missing ring, screenshots showing the recall marked completed, and Stellantis’ confirmation to the dealership before having the vehicle towed to verify coverage. The truck was towed to Time Chrysler Dodge Jeep Ram of Portland. My initial contact was [XXX] at that location. However, all recall decisions and communication later came from [XXX] , who works at a different dealership. Over the next month, the dealership repeatedly stalled the recall, saying they were waiting on approval from the district manager and then from the recall department, but no action was ever taken. Despite having Stellantis’ written confirmation and clear photographic evidence of the unresolved defect, the dealership refused to perform the recall. They insisted on treating it as a “warranty” issue and cited reasons such as mileage, age, and not being the original owner—none of which apply to safety recalls. They then stated that teardown and diagnosis “would run $1000,” even though the defect has already been documented by both the mechanic and Stellantis. All communication, including photos, the mechanic’s findings, Stellantis’ confirmation of coverage, and the dealership’s refusal, is available upon request. The truck has now been sitting at the dealership for over a month with an unresolved safety defect. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Was just driving and the engine shut off and a check engine light came on and won’t start again believe timing chain failed

2010 Dodge Ram 1500 truck purchased used late May 2025 with 57000 miles. Late August 2025 with 60000 miles rear axle fell off when driving on Freeway at 60 miles per hour. Very serious accident was narrowly avoided as could not steer vehicle.Truck was serviced at dealership for recall of a pinion nut coming loose at 36107 miles in September 2013. Per this recall, the loose pinion nut can cause the axle to fail. The recall maintenance done in September 2013 at 36107 miles only lasted 24000 miles and serious safety issues reoccurred. In my opinion, on my vehicle the recall did not fix the problem. Now I am stuck with a $5000 repair on a vehicle with known recalls and safety issues that was supposedly fixed.Perhaps a second recall should be considered regarding this issue.

Me and my husband were driving down the road to go see a friend and all of a sudden the wheel hub assembly broke in half causing us to have to slam on our brakes and keep from crashing. The wheel almost ended up under our truck making the truck look like it was kachowing like Lightening McQueen from the movie Cars

Me and my husband were driving down the road to go see a friend and all of a sudden the wheel hub assembly broke in half causing us to have to slam on our brakes and keep from crashing. The wheel almost ended up under our truck making the truck look like it was kachowing like Lightening McQueen from the movie Cars