2011 DODGE RAM 3500 — Problems, Recalls & Safety Data

The contact owns a 2011 Ram 3500. The contact stated that the OEM trailer brake controller indicated that the trailer brake was disconnected even though it was attached correctly. The failure occurred while different trailers were hitched to the vehicle. The vehicle was taken to a certified mechanic, but the cause of the failure was not determined. The contact replaced the OEM brakes with new OEM brakes; however, the failure persisted. The vehicle was taken back to an independent mechanic, who diagnosed and determined that there was not enough amp signal to recognize that the trailer was connected. The mechanic attached a magnetic pigtail line with magnets attached to both ends, and the vehicle recognized that the trailer was connected. The cause of failure was found; however, the vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was 145,000.

While driving 70mph on the interstate, the truck randomly shut off. I lost power steering. Luckily I was going straight and there were no curves in the road, and I managed to pull the truck and trailer to the side of the road. All electrical assist, steering and brakes turned completely off, radio turned off, all electrical power was off. The engine shut off as well. As I was pulling over, the electrical turned back on but the engine did not. Once I was stopped, I turned the key off, waited 30 seconds, and then started the truck. It ran fine the rest of the way home, approximately 30 miles. I have not drove the truck since. This has happened 3 times, once parked idling after I pressed the door unlock button and the other time in the middle of an intersection. I took the truck to the dealership, paid for the inspection fee, but they could not recreate or find any wiring problems. It did throw a code when it happened, U0121 (Lost communication with ABS module). The dealer said they had to recreate it to diagnosis. I am fearful if I continue to drive the truck to pull my trailer, this could happen again while I am in a turn and I will not be able to continue to turn or stop the vehicle without electrical assist. Dodge does not seem interested in trying to fix this safety issue.

The contact owns a 2011 Ram 3500. The contact stated that during cold weather, the engine would not heat up properly and hesitated to start. In addition, the contact stated that on several occasions, the heater grid connector on the driver's side melted bolts and wiring that intruded into the engine, causing piston #6 to misfire. The contact related the failure to NHTSA Campaign Number: 23V060000 (Electrical System) however, the VIN was not included. There was no warning light illuminated. The local dealer was contacted; however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 96,000.

The contact owns a 2011 Ram 3500. The contact stated that during cold weather, the engine would not heat up properly and hesitated to start. In addition, the contact stated that on several occasions, the heater grid connector on the driver's side melted bolts and wiring that intruded into the engine, causing piston #6 to misfire. The contact related the failure to NHTSA Campaign Number: 23V060000 (Electrical System) however, the VIN was not included. There was no warning light illuminated. The local dealer was contacted; however, the VIN was not included in the recall. The manufacturer was made aware of the failure. The failure mileage was approximately 96,000.

The contact owns a 2011 Ram 3500. The contact stated that on several occasions while attempting to make a right turn, the steering wheel seized. No warning light was illuminated. The failure occurred on several occasions. The vehicle was taken to the dealer where it was diagnosed but the cause of the failure was not yet determined. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 20,000.