2011 DODGE RAM 3500 Electrical System Integrated Trailer Brake Control Problems

The contact owns a 2011 Ram 3500. The contact stated that the OEM trailer brake controller indicated that the trailer brake was disconnected even though it was attached correctly. The failure occurred while different trailers were hitched to the vehicle. The vehicle was taken to a certified mechanic, but the cause of the failure was not determined. The contact replaced the OEM brakes with new OEM brakes; however, the failure persisted. The vehicle was taken back to an independent mechanic, who diagnosed and determined that there was not enough amp signal to recognize that the trailer was connected. The mechanic attached a magnetic pigtail line with magnets attached to both ends, and the vehicle recognized that the trailer was connected. The cause of failure was found; however, the vehicle was not repaired. The manufacturer was not informed of the failure. The failure mileage was 145,000.

TL* THE CONTACT OWNS A 2011 DODGE RAM 3500. THE CONTACT WAS DRIVING 10 MPH WHEN THE BRAKES WERE DEPRESSED BUT VEHICLE FAILED TO STOP PROPERLY. THE VEHICLE WAS TAKEN TO THE DEALER AND THE MANUFACTURER WAS MADE AWARE OF THE FAILURE. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS 450 AND THE CURRENT MILEAGE WAS 5,600. UPDATED 01/18/12 LJ THE CONSUMER STATED THE PROBLEM WAS WITH THE FACTORY INSTALLED TRAILER BRAKE CONTROLLER. IT DID NOT APPLY THE TRAILER BRAKES PROPERLY. IT WOULD WORK, WHEN THE MANUAL LEVEL WAS USED, BUT NOT WHEN THE TRUCK BRAKES WERE APPLIED. UPDATED 01/19/12