2010 TOYOTA SEQUOIA — Problems, Recalls & Safety Data

Odometer Fraud. The contact purchased a 2010 Toyota Sequoia. The contact stated that while attempting to register the vehicle, it was discovered that there was a mileage discrepancy. The vehicle was a private sale. At the time of purchase, the vehicle mileage was 90,586, and at the time of checking the Carfax, it was discovered that the mileage was 260,000.

Power steering rack assembly malfunctioned and started shaking violently. Upon inspection, a fluid leak was found from the passenger side of the steering rack.

The contact owns a 2010 Toyota Sequoia. The contact stated while driving approximately 35 MPH, he noticed that the rear wheels were extended outward. The contact looked under his vehicle and noticed that the rear subframe and suspension were extremely rusted. There were no warning lights illuminated. The vehicle was taken to a local dealer; however, there was no diagnostic test performed. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 184,000.

The contact owns a 2010 Toyota Sequoia. The contact stated that while driving approximately 60 MPH, the vehicle suddenly experienced unintended acceleration and the speed continued to increase. While depressing the brake pedal, the speed continued to increase and exceeded 95 mph. The driver used the parking brake to eventually stop the vehicle and turn off the engine. After restarting the vehicle, the RPM continued to rev very high. The vehicle was towed to the local dealer. The cause of the failure was not yet determined. The contact was informed that the vehicle was not included in NHTSA Campaign Number: 10V017000 (Vehicle Speed Control). The contact indicated that the vehicle had experienced the failure listed in the recall. The approximate failure mileage was 120,000.

The contact owns a 2010 Toyota Sequoia. The contact stated that the check engine warning light was illuminated. The vehicle was taken to an unknown dealer to be diagnosed. The contact was informed that there was moisture and condensation in the air injection pump and the air switching valve. The contact stated that there was a manufacturer’s warranty pertaining to the failure causing the check engine warning light to become illuminated however, the warranty was for 150,000 miles or 10 years, whichever came first. The vehicle was no longer covered under the warranty. The manufacturer was notified of the failure. The vehicle was repaired. The approximate failure mileage was 103,000. "The contact was informed that there was moisture and condensation in the air injection pump and the air switching valve." since this is not correct. The dealer only said that the items needed to be replaced due to the indicator light. They could not verify that there was a specific issue with the parts but said that it was an indicator that the parts could go bad and needed to be replaced.