2021 JEEP GLADIATOR Air Bags Problems

The contact owned a 2021 Jeep Gladiator. The contact stated that while the vehicle was stopped at a corner, another vehicle was speeding and crashed into the front driver's side quarter panel. The impact pushed the vehicle forward, causing the front driver's wheel to swipe a telephone pole before landing on a residential lawn. The other vehicle then crashed into a telephone pole. The front driver's side air bag deployed, but there was a hole in the side air bag and the driver's air bag failed to fully deploy. Additionally, a burning odor was detected after the air bags deployed. The police and fire departments arrived on the scene, and a police report was filed. The contact was transported to the hospital by ambulance. The contact had surgery on her left arm from wrist to elbow, which required four titanium plates. The vehicle was towed to the tow yard and deemed...

While driving multiple warnings appears on the dash including bus communication, airbag, transmission communication, and abs. The vehicles engine began to randomly change rpm. The transmission began to shift speratically and was unable to maintain speed. The vehicle would not allow me to turn on hazard lights to warn surrounding motorists. Similar warnings appeared on the dash once before and the vehicle would not start and left me stranded. When taken in for service for the no start issue, the dealer performed no repairs for this issue and stored P codes were cleared prior to the vehicle being returned to me. I am currently awaiting a service appointment for the issue that happened while driving.

Air bag sensor fails to properly sense a passenger in the passenger seat and the service airbag warning light cycles on and off. To keep it from cycling - one must disconnect the sensor. I have contacted the dealer to diagnose the problem. The condition occurred after starting the vehicle and occurs whether there is a passenger or not. It also occurs while the car is in run mode. Airbag will not function or may deploy with too much force

The failure of the vehicle’s safety condition check for an empty driver’s seat for an auto stop indicates that the “Occupant Restraint Controller (ORC)” and/or the “Advanced Front Air Bag system” are not receiving proper information. This creates a serious safety hazard as the front air bags may not deploy or may not “adjust the inflation rate of the Advanced Front Air Bags” as specified in the owner’s manual. For driver safety, these systems and their associated sensors should be fully examined and tested. The vehicle auto stops when the driver’s seat is not occupied, in direct conflict with owner’s manual. The owner’s manual specifically states that if the “Driver’s seat is not occupied” that the “engine will not stop.” Note that this system safety check is separate and distinct from the “Driver’s seat belt is not buckled” check. The vehicle fails to properly check for the empty driver’s seat...