2021 GRAND DESIGN IMAGINE Suspension Problems

The right side leaf spring hanger broke from the frame while traveling causing the trailer to lean heavily and pull to the right side nearly hitting an 18 wheeler that I was passing. I received a customer satisfaction campaign letter from Grand Design 3 days later in regard to cracks in the I beam frame above the spring hangers for all Imagine 2910BH models produced between 6/24/2020 and 6/14/2023. Grand Design said that they have concluded that condition does not present a safety hazard. Having a suspension component fail on a trailer is a safety hazard.

After reading of other owners of similar and identical models like mine having frame cracks, I made a point to inspect my trailer’s I beam chassis and I discovered horizontal cracks within the I beam, one on each side, over the suspension area. Every picture I have seen looks just like mine, a rusty L shaped crack adjacent to a crossmember welded on the backside of this area. You can see the shape of this crossmember through the surface of the I beam, indicating the metal is quite thin. It took me only a couple minutes to find, as I knew exactly where to look, based on the numerous stories I’ve read about. Upon further inspection, I also found suspect welds that look burned through the frame, leaving a hole behind. This makes me question the quality of the rest of the trailer’s frame. There is also a crossmember at...

Cross member of frame bending, allowing A frame that its connected at to also bend.

Suspension hangers cracked the frame and a section of the frame broke allowing the hanger to flip over and suspension to fail. This occurred while backing the trailer up. If it occurred while driving it could have caused the trailer to tip over.

We were driving and went through a dip in the road and the whole front end of the A- Frame bent/buckled. We have not had any problems with this in the past, but it is a brand new trailer and we are learning it has happened to a few others all Grand Design XLS series. We wonder if the steel used is not of top quality and is too thin.