2021 CHRYSLER PACIFICA Wheels Problems

Vehicle is new and delivered on 08/27/21. Complaint: The front axle nuts on vehicle loosen over time. The first incident was reported to I-10 Chrysler Dodge Jeep Ram on 09/29/23 (see Invoice), with 24,832 miles as a noise coming from the front left suspension. This dealer replaced both front hubs at that time which resolved the noise. The second incident was reported to Chrystal Chrysler Jeep Dodge Center on 02/13/24 (see Invoice) with 27,952 miles as a noise coming from front left axle. Dealer mechanic went on test drive with me and found noise coming from front left axle shaft nut. RO states, "Found axle nut not torqued to specs. Tight down left front axle nut. Test drove vehicle. No noise found after repair.". The third incident was reported to Hemet Chrysler Dodge Jeep Ram on 08/26/25, and I asked them to check the torque on the front axle nuts....

Car would make a grinding noise over 5mph. We looked under the vehicle to find a loose bolt to the left of the left tire.

OEM equipment wheel locks, incorrectly installed either at factory or dealer, were McGard high security wheel locks, and either incorrectly tightened/torqued and/or the equipment used was warned by the mfg of the wheel locks NOT to be used on wheels where the lug studs were exposed to salt/winter conditions, thus causing the OEM equipment to fail and seize on the van. At the first DEALER performed tire rotation, they could not remove the OEM equipment, on a WARRANTED auto just 18 months into the mfg 3yr/36k mile warranty, and had to resort to brute force to remove seized wheel locks, thus causing documented damage to 2 wheels. Neither Dealer nor Chrysler will admit to liability, tuning this back on me, disregarding their warranty. Full documentation available for this claim. Their denial is not based on any contractual issue in warranty nor in any real fact. Had I had a flat...