2015 AUDI SQ5 — Problems, Recalls & Safety Data

Rear subframe has extensive and significant rust affecting the structural integrity of the critical component…. Have been advised by a qualified certified mechanic that the vehicle should NOT be driven as doing so could result in catastrophic collapse of the vehicle suspension with potential loss of control of the vehicle without warning. This is apparently a known issue with this model vehicle and the manufacturer has not issued any formal warnings or recalls……

Rear subframe has extensive and significant rust affecting the structural integrity of the critical component…. Have been advised by a qualified certified mechanic that the vehicle should NOT be driven as doing so could result in catastrophic collapse of the vehicle suspension with potential loss of control of the vehicle without warning. This is apparently a known issue with this model vehicle and the manufacturer has not issued any formal warnings or recalls……

Rear subframe structure has rusted through in the same location on both sides of the car. Moisture is being trapped between a plastic pieces of molding and the subframe and causing it to rust out completely.

The contact owns a 2015 Audi SQ5. The contact stated while driving at approximately 65 MPH, while the brake pedal was depressed, the brakes failed to engage; the contact had to initiate the emergency brake to bring the vehicle to a halt. No warning light was illuminated. The vehicle was towed to an independent mechanic to get a diagnosis however, the diagnosis was pending. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 108,084.

The contact owns a 2015 Audi SQ5. The contact stated while driving at approximately 40 MPH, there was an abnormal scraping and dragging sound coming from the front of the vehicle. The contact stated there was no warning light illuminated. The contact pulled over and observed that the plastic cover for the rear frame was loosened and was dragging on the roadway. The contact was able to remove the remaining piece of the plastic cover by hand. The contact had taken the vehicle to a local dealer, where it was diagnosed and determined that the rear subframe was severely corroded and needed to be replaced. The vehicle was not repaired. The manufacturer was informed of the failure. The failure mileage was approximately 110,000.