NHTSA Complaint #11693274 — 2024 JEEP WRANGLER

On October 13, 2025, I experienced three separate incidents involving my Jeep Wrangler 4xe while driving in Hybrid Mode at approximately 35 mph. First incident: Around 5:10 PM, the vehicle suddenly lost speed, stalled erratically, and displayed the message “Shift to D to Drive” on the screen while the “D” on the gear selector was flashing. The check engine light also came on. I was able to safely pull over and restart the vehicle. Second incident: Around 5:13 PM, less than a mile later, the same issue occurred again while the check engine light remained on. I again pulled over and restarted the vehicle. Third incident: Around 5:20 PM, the same problem repeated for a third time. After the third occurrence, I called the dealership where I purchased the vehicle to report the issue. The service department representative immediately recognized the problem and informed me that 13–14 vehicles had already come in that same day with the same issue. Because I was only about 3 miles away, I drove carefully at low speed with my hazard lights on and dropped off the vehicle at the dealership. At the service center, the staff member stated that it might be an electrical issue possibly related to a recent Uconnect+ software update. However, I had not received any prior information, warnings, or recall alerts regarding this issue — neither through the Jeep app nor by email. I am especially concerned that the dealership was aware of multiple vehicles with the same issue yet provided no notification to affected owners. I later discovered that other Jeep Wrangler 4xe owners have reported the exact same issue — the dash blinking “D” while driving, sudden loss of motive power, and the message “Shift to D to Drive” appearing even though the vehicle was already in drive. These reports match my experience precisely, indicating that this is not an isolated problem. This is an extremely serious safety issue. The vehicle’s loss of motive power while driving unexpectedly puts drivers and