NHTSA Complaint #11655556 — 2020 FORD EXPLORER

The vehicle was driven to the destination and then turned off. Upon turning the vehicle back on and attempting to drive it, the vehicle vibrated and shuttered violently at times. The vehicle was looked over on-site before being driven to a mechanic for any loose parts or debris in the fender wells. The vehicle was able to be driven slowly to mechanic and only wide turns could be made or it would shudder and vibrate. After inspecting the vehicle, the mechanic stated that the front axles needed to be replaced and this would solve the issue. Approval for the front axle replacements to be completed was given to the mechanic and the soul was completed. However, the vehicle continued to vibrate and shudder in forward and reverse gears, especially when turning. The mechanic suggested to go to the dealership to get it checked out and reset/reprogram the PCM. The vehicle was taken to the dealer who looked it over and checked for a rear axle bolt failure and then sent it back to the original mechanic to swap the axles as they are unsure if the correct parts were installed. The original mechanic contacted the Ford dealership and ordered the front axles again and installed them. The problem persisted. The mechanic then attempted the completion of the TSB 23-2174 to see if that would help solve the problem. The vehicle was then driven to the dealership to have the PCM reprogrammed and the work completed by the mechanic reviewed. After leaving the vehicle at the dealership for several weeks and having the work completed, the problem persists. However, since this problem started, the transmission or drive train now slips or hips when coming to a stop right at 0mph. It also pops and jumps when taking off in the lower gears.the drive train behaves erratically and feels like something is loose or slipping or of place. The rough shifting and hop when stopping causes concern about the vehicle not stopping or shifting out of gear or into the strong gear or something is coming loose