NHTSA Complaint #11567253 — 2020 JEEP WRANGLER

In September of this year, I would get a random code thrown by the computer, usually telling me that the sway bar disconnected required service, but sometimes it was also the 4wd system. These codes would reset themselves within a few minutes, but I still took it to a dealership for a checkup. The dealership told me that since it currently was not throwing any codes there wasn't really anything they could do. The problem continued to worsen over the next few months. The codes thrown become more varied. I took the vehicle to the dealership two more times and again, no solution was found. Sometimes in the morning when I would go to start the vehicle, it would start, but would not allow the shifter to move, saying that service was required. I took it to the dealerhip again, and no solution could be found. Then the worse started happening. The computer would start throwing several codes at the same time, and then enter a reboot cycle, as I was driving down the freeway. During the reboot cycle, power to the accelerator and power steering would flap on and off, and my ability to steer the vehicle would alternate between powered and unpowered within seconds, leading to a very dangerous situation. The accelerator was the same, disabling my ability to respond to the conditions on the road. I escalated to Jeep's corporate system and left my Jeep at the dealership for two weeks. They were eventually able to identify the CAN BUS as the problem and replace it. I was informed that this was a common problem in Jeep Chrysler vehicles. SInce the replacement of the CAN BUS, I have not experienced any further incidents.