2024 WINNEBAGO EKKO Electrical System Problems

9 NHTSA complaints on file

Check any vehicle history by VIN - Free vehicle history report

Electrical System Issues in the 2024 WINNEBAGO EKKO

9 electrical system complaints have been filed with NHTSA for the 2024 WINNEBAGO EKKO. Of these, 0 involved a crash, 3 involved a fire, and 0 resulted in injury.

9
Complaints
0
Crashes
3
Fires
0
Injuries
0
Deaths

All Electrical System Complaints

#11707214 |
The second alternator, Balmer, used to charge the lithium batteries overheated and failed. It is located under the hood near the engine. It made a whining sound and failed to charge. I took it to Camping World in Marysville and they said the sound was “normal” and preformed the deregulation . A few months later, I brought it back and after insisting on inspection and calling Winnebago, they said it had failed. This is the second time it has failed. I am still waiting for a replacement as Winnebago says they are back ordered. I am now without a charging system, but at least my vehicle didn’t catch on fire like others have. This is an unacceptable problem that Winnebago refuses to remedy.
#11702351 | Fire
The 2024 Winnebago Ekko Ford Transit base includes standard a second alternator in the engine bay manufactured by Balmer and installed by Winnebago to charge the house batteries, in this case two 320amp batteries manufactured by Lithionics. A service recall was completed by Winnebago Authorized Dealer in 6/2025 to reduce the charge capacity based on prior failures and fires in the alternator. Our vehicle has 26,000 miles and have had no indication of failure. After an 80 mile drive, we smelled burning electrics and smoke came from under the hood. I applied a fire extinguisher from underneath on the alternator to stop the burning and disconnected the alternator from the electrical system. I am aware of this happening to many additional owners via a group forum. Ultimately, it appears Winnebago has change suppliers of this alternator, but those with the original are subject to this risk. Also, many have replaced...
#11648395 | Fire
In October 2024 our Rv was brought to the dealership due to the RV making a high pitch noise while driving. The dealership concluded that it was the Balmar alternator that needed to be replaced. March 2025 the Solar recall was completed as well as the alternator replaced. After a 30minute drive smoke was coming from underneath the hood and the alternator caught on fire. Luckily nobody was hurt and the fire was contained only because we were on alert due to so many other Ekko owners having the same problem!
#11627262 |
This is a 2024 Winnebago EKKO (drivable RV). It has a second alternator (manufactured by BALMAR) for charging the house (RV) battery(s). On July 26th of this year (2024) our BALMAR alternator started to make a high pitched noise and failed to correctly charge the house battery. When I did some diagnostic work I noticed it was overheating. This issue has been reported numerous times so I knew what to do. I immediately unplugged the BALMAR device (disconnected the 4-wire connection to the BALMAR control center located next to our battery compartment) and scheduled an in-warranty service appointment with Winnebago in their Forest City, Iowa service center. On Sept 10th (2024) we had our Winnebago service appointment where they removed the BALMAR alternator (located under the Ford engine) and informed us it was cracked (like many others they had seen). It was replaced under Winnebago Warranty. They were great and...
#11621634 |
The A/C on our 24E/24T EKKO stopped working today, October 13, on old Route 66 in Oklahoma. The ICM870-16A-BH5400 easy start circuit board was fried. A portion of the circuit board had melted and the brown wire was loose and the connector melted. The ICM cover fell loose when I removed the GE A/C cover. See the attached photos. The ICM870-16A-BH5400 is included in GE Kit GEASST-1. The BH5400 suffix is unique to the GE sourced easy start. This may not be important, but upon inspection, using ICM680 installation instructions on-line (see attached), I noticed that the red and white/blue wires from the ICM controller were switched on the run capacitor H and C terminals. I assumed that the wire colors shown on the installation wiring diagrams are the same for all ICM680 controllers and all applications. If the installations are the same for all ICM680 controllers, then the red...
#11618791 |
The Balmar alternator is going bad on my 2023 transit on my 2024 Winnebago Ekko. It is starting to whine which in the past leads to a fire in the engine compartment on others units. It is recommended to pull the 4 wire plug that goes Balmar regulator in the lithonics battery compartment, which I did to prevent any additional damage. So without the Balmar unit the batteries will only charge plugged into shore power. A Winnebago group recommended reporting this problem to NHTSA Thank you.
#11618350 |
The second alternator, manufactured by Balmar and installed by Winnebago, failed. It began producing an audible whine whose pitch and volume corresponded approximately to engine RPM. The power output from the alternator began dropping, eventually reaching about 10-20% of normal. Additionally, after some time (several hours of driving), an odor of burning plastic was detected. At that time, we stopped the vehicle and disconnected this alternator, and the whine and odor has ceased since. No smoke or fire was detected, but we do suspect damage to the alternator, and have left it disconnected in the interest of safety. The primary alternator in the Ford chassis does not appear to be affected, only the secondary Balmar alternator installed by Winnebago. Note that a previous NHTSA recall applied to this vehicle model for apparently similar issues, but our unit was manufactured subsequent to and was not subject to that recall. We have...
#11608593 |
The Zamp solar charge control panel 30 amp fuse melted. The wires got very hot. The solar charging system is overheating and susceptible to fire. We believe Winnebago is aware of this issue and is documented under NHTSA Campaign Number 25V-541. We were made aware of the potential problem by a Winnebago users Facebook group. When we opened the panel to inspect the fuse, it was melted so much that we cannot remove the fuse. We weren't aware of a problem due to any symptoms. The Balmar alternator and MC-618 regulator overheated and caused the 250 amp circuit breaker to blow and then the alternator went into a lock out state. The alternator is not charging the Winnebago batteries now which impacts how we can use the RV. We cannot unlock it ourselves and there are numerous reports of this happening after Winnebago recall 174.
#11608293 | Fire
Fuse for Zamp controller on 2024 Transit Ekko class C camper melted and caused a fire. Due to insufficient oxygen, the fire luckily self-extinguished.
Check any vehicle history by VIN - Free vehicle history report