2021 MERCEDES-BENZ AMG GLE53 — Problems, Recalls & Safety Data

According to the dealer, there are fault codes in the system for Transmission control unit failing. Thats what caused the vehicle to go into "limp" mode... That needs to be replaced. In an instant, the warning lights and reduction in power occurred simultaneously. The car slowed down and had to coast to shoulder of the highway crossing multiple lanes of traffic. The warnings that came on said “car cannot shift”, “battery failure warning” and when stopped; “do not restart the car.” The shoulder was very narrow and we could have easily been hit by the cars passing at high speeds on the beltway. We had to wait 2 hours for Mercedes roadside assistance to arrive. The dealer is saying it will be $6,000 to repair this.

Engine harness wires insulation is falling apart very early after 3 years. It’s causing arching inside the insulation. Issues is from overheating and can cause a fire. Isolation needs to be upgraded and wire harness needs replaced.

Vehicle unexpectedly lost power on a major highway. Limped into a service station, called for a tow truck. Several days later vehicle was repaired with a bill of $2800. Four weeks later, while driving, check engine light comes on. Contact dealership that completed repairs, brought car in. Now it’s the 48V Hybrid battery needs to be replaced, $4000. Based on some cursory research, this is a known problem in these cars. Mercedes Benz needs to be held accountable. The car was purchased brand new three years ago.

Vehicle unexpectedly lost power on a major highway. Limped into a service station, called for a tow truck. Several days later vehicle was repaired with a bill of $2800. Four weeks later, while driving, check engine light comes on. Contact dealership that completed repairs, brought car in. Now it’s the 48V Hybrid battery needs to be replaced, $4000. Based on some cursory research, this is a known problem in these cars. Mercedes Benz needs to be held accountable. The car was purchased brand new three years ago.

Purchased as a CPO directly from a local dealership. Vehicle has experienced multiple (10+), seemingly random failures of the Electronic Stability Control, Blind Spot Assist, Lane Keeping Assist and Active Break Assist under varied driving and weather conditions. On two separate occasions (one at 15+ mph and the other at 65+), these system failures were accompanied by a brief "limp mode" and immediate total loss of acceleration. The most recent loss-of-acceleration event occurred during lunch hour traffic on the highway, at highway speeds. The vehicle has been taken to the dealership to address these issues on 3 separate occasions. Visit #1: the communication fault codes were noted by the technicians, but they could not replicate the issues. The faults were cleared and the vehicle service was deemed complete. Visit #2 (3 days later and the first instance of acceleration loss): report from service department reads almost identical to that of Visit #1 except the notation that "...found several stored faults for communication with engine control unit." Again, the issues could not be replicated and the faults were cleared. Viewed as an unacceptable response by the consumer, the dealership retained the vehicle for further troubleshooting with the follow-on report noting, "Found no socket tension at Sockets 27 and 28 to PTCU. Removed and replaced sockets 27 and 28 at ME connector 6." The faults were, again, cleared and the vehicle was returned to the owner. Visit #3 (roughly 5 weeks after last visit and the second instance of acceleration loss, this time on the highway): The same complement of warning lamps illuminated, the car lurched, and there was zero acceleration. The vehicle was navigated to the highway's shoulder without incident and shut down. After 5+ minutes, the vehicle was restarted and acceleration functioning had returned. It was immediately driven to the dealership where it currently awaits repair.