2024 FORD RANGER Structurebody Problems

Didt show how close car was to pole

[XXX] [XXX] [XXX] [XXX] 3/12/2025 National Highway Traffic Safety Administration 1200 New Jersey Avenue SE Washington, DC 20590 Subject: Complaint Regarding 2024 Ford Ranger Raptor VIN [XXX] Dear NHTSA Team, I am writing to formally report a safety issue with my 2024 Ford Ranger Raptor, VIN [XXX] . After purchasing this vehicle, I encountered a significant problem that I believe poses safety concerns. Recently, I learned that Ford has developed a solution for this issue, as detailed in the following press release: WSAV Press Release. However, Ford is unwilling to cover the necessary repairs under warranty, despite the fact that this solution became available shortly after my purchase. I believe that this situation requires your attention, as it not only impacts my vehicle but may affect other owners of the same model. I urge the NHTSA to investigate this matter to ensure that safety standards are upheld and that consumers...

Not sure if this is the correct channel, but here goes my concern. The safety incident has not yet occurred, but the manufacturer has stated it could/may occur if a certain fix is not performed, but are unwilling to issue a recall for said fix, or even produce the parts they say are necessary to implement the fix. I own a 2024 Ford Ranger Raptor that Ford has demonstrated has a design flaw in their bed (for vehicles produced before mid Sept, 2024) in that it cannot carry more than 88 lbs on the bed rails without the potential for failure. I need to install a topper to protect and secure cargo in the bed which will exceed the 88 lb failure number they state. The fix they say must be implemented is to install 2 Ford supplied load box reinforcement brackets (called J-braces), yet I've been trying to order/obtain...

I purchased a new 2024 Ford Ranger yesterday. As I was researching camper shells and truck racks I found that these common items cannot be installed without first installing a load bed reinforcement bracket kit to reinforce the truck bed to the bed side rails. Apparently, nothing can be attached to the side rail which weights more that 88 lbs or the truck bed could separate from the side rails. This is an design/engineering shortcoming from Ford as these are common after market add-ons for mid-sized trucks. Also, Ford is asking customers to pay for the reinforcement bracket and installation - which was quoted today at $1,600, and the Ford part is not currently available from the corporate US Ford website, and has not been available for several months.

2024 Ford Ranger Trucks made in Michigan between January 4, 2024 to July 15, 2024 do not include the load box reinforcement bracket. Without this bracket installed, if the owner were to place more than 88lbs onto one or both bed side rails the bed could crack, warp, bend, or break. If operators of this vehicle are not aware and do load the bed side rails over 88lbs, this could pose a safety issue to the driver or other drivers on the road around the vehicle. Ford has not notified all owners of affected vehicles, and in my case I found out my vehicle was affected out of sheer curiosity and reading forums with posts of other owners whose vehicles are also affected. Ford is currently not willing to address the issue without additional cost burden on the vehicle owner.