2008 FORD ESCAPE — Problems, Recalls & Safety Data

The power steering started going out at low speeds and eventually just stopped working. The car keeps saying power steering assist fault. The power steering no longer works.

Forscan showing torque sensor malfunction, the same issue that was recalled in 2014. Causing loss of power steering

The contact owns a 2008 Ford Escape. The contact stated that occasionally, while driving at various speeds, the steering wheel became difficult to turn in either direction. An unknown warning light was illuminated, and an audible ringing sound was coming from the vehicle. The local dealer was contacted; however, the vehicle was not diagnosed or repaired due to the cost. The contact associated the failure with NHTSA Campaign: 14V284000 (Steering); however, the VIN was not included. The manufacturer was not made aware of the failure. The failure mileage was approximately 200,000.

The electronic power steering stopped working and it is almost impossible to move or turn the car. Dashboard shows fault. This is a Ford Escape Hybrid 2008 model with 142,000 miles. The car has not been repaired and I have yet to take it to a Ford dealership.

Vehicle: 2008 Ford Escape VIN: [XXX] Component: Steering – Electric Power Steering Assist Recall Involved: 14S05 / NHTSA 14V-284000 Description of the Safety Problem: My vehicle is experiencing a recurrence of electric power steering assist failure after a prior safety recall repair. This 2008 Ford Escape was subject to Safety Recall 14S05 (NHTSA Campaign 14V-284000), which addresses sudden loss of electric power steering assist due to a torque sensor fault. This condition can occur while driving and results in significantly increased steering effort, creating a safety risk. Ford records show the recall was marked “completed” on November 22, 2014. In a written response dated December 22, 2025, Ford Motor Company confirmed that the recall remedy consisted only of software reprogramming of the Power Steering Control Module (PSCM) and Instrument Panel Cluster (IPC). No mechanical components (including the torque sensor or steering column) were replaced. In 2025, the same steering assist failure recurred, resulting in heavy steering effort and renewed safety concerns. This indicates that the recall remedy did not correct the underlying defect. Ford Motor Company has acknowledged in writing that: The recall was software-only The recall is closed No current programs provide coverage for the recurring steering failure Ford denied further assistance strictly on eligibility grounds and did not dispute the recurrence of the defect or its safety implications. Because this is a recurrence of the same safety-related defect addressed by the recall, I am concerned that the recall remedy was inadequate, and that other vehicles repaired under this recall may also experience recurrence after software-only updates. I am submitting this complaint to request NHTSA review of: The adequacy of Recall 14S05’s remedy Whether a software-only repair sufficiently addresses torque sensor failure The safety implications of recurring steering assist loss after recall completion Loss of INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATIO