2001 DODGE RAM QUAD CAB — Problems, Recalls & Safety Data

CRACKING DASH BOARD ON DRIVERS SIDES

THIS TRUCK IS USED TO HAUL A CAMPER AND A CAR TRAILER FOR MY SHOW CARS. TODAY I STARTED TRUCK TO HOOKUP TO CAR TRAILER FOR THE FOURTH TIME TIME THIS YEAR. THIS TRUCK IS NOT DRIVEN IN THE WINTERS YET WHILE BACKING UP TO THE TRAILER I PRESSED ON THE BRAKE PEDAL TO HAVE THE BRAKE PEDAL GO TO THE FLOOR. I FOUND THAT THE LINE GOING TO THE REAR IS RUSTED NEAR THE FUEL TANK AND SPRAYS BRAKE FLUID ONTO THE FUEL TANK. ALSO A LINE FOR THE FRONT BRAKES COMING DOWN FROM THE ABS UNIT FAILED AT THE SAME TIME. I HAVE BRAKE FLUID SPRAYING EVERYWHERE. THIS CAUSED A COMPLETE BRAKE SYSTEM FAILURE. IT APPEARS THE OEM COATED ALL OTHER UNDER VEHICLE COMPONENTS YET LEFT THE BRAKE LINES RAW STEEL. I WRITE THIS AS A SEARCH TO WEB TO FIND THIS IS OCCURRING OVER AND OVER AGAIN. SOMETHING NEEDS TO BE DONE AS IF THIS HAPPEN TO ME AFTER HIT THE ROAD WITH 9,000 LBS OF TRAILER BEHIND ME WITH NO BRAKES EITHER MYSELF OR SOMEONE ELSE ON THE ROAD COULD HAVE BEEN KILLED.

BOUGHT A 2001 DODGE QUAD CAB SPORT 4X4 IN 2003. THE DASH HAD A SMALL CRACK ON THE DRIVERS SIDE AT TIME OF PURCHASE. THE CRACK SPREAD RAPIDLY TO ALL AREAS OF THE DASHBOARD. I USED PROTECTANTS, ADHESIVES AND DASHBOARD SHADES AND A DASH PAD TO PREVENT FURTHER SPREAD TO NO AVAIL. DURING ONE EVENING TRIP,I HIT A BUMP IN THE ROAD AND THE ENTIRE DASH CAVED IN CAUSING THE INSTRUMENT CLUSTER TO LOSE LIGHTING. I HAD TO COLLECT ALL THE EXTREMELY SHARP SHARDS OF PLASTIC OUT OF THE DASHBOARD RECESS TO LOOK FOR THE PROBLEM. IT WAS DURING THIS INCIDENT THAT A EXTREMELY SHARP PIECE OF PLASTIC CUT DEEP INTO MY RIGHT HAND. I SHOULD HAVE GOTTEN STITCHES, BUT USED GAUZE AND WRAP UNTIL HEALED. WHAT WOULD HAVE HAPPENED IF THE AIRBAG WAS DEPLOYED WITH LOOSE PLASTIC PARTS FLYING ALL OVER THE PLACE? SURVIVE THE CRASH AND THEN DIE FROM MASSIVE LACERATIONS FROM BROKEN DASH PIECES? I CONTACTED MULTIPLE LOCAL DODGE DEALERS AND WAS TOLD THAT THEY KNEW AND CORPORATE KNEW OF THE PROBLEM, BUT THEY WOULD NOT REPLACE IT BECAUSE DODGE CORPORATE WOULD NOT AUTHORIZE OR PAY FOR THE OBVIOUS MANUFACTURING DEFECT. I PROBABLY WILL NEVER BUY A DODGE AGAIN. DODGE KNEW THIS WAS A BIG PROBLEM, BUT DID AND STILL DOES NOT CARE. ALMOST EVERY DODGE I'VE SEEN WITHIN THE 2000-2003 YEARS HAS THIS BLARING PROBLEM. SOME HAVE REPLACED THE DASH WITH AFTERMARKET PARTS OR JUST TRY TO COVER IT UP WITH DASH PADS OR MATS. DOES THE NHTSA CARE? HAS THIS MASSIVE ISSUE EVEN LOOKED INTO? *TR

BOUGHT A 2001 DODGE QUAD CAB SPORT 4X4 IN 2003. THE DASH HAD A SMALL CRACK ON THE DRIVERS SIDE AT TIME OF PURCHASE. THE CRACK SPREAD RAPIDLY TO ALL AREAS OF THE DASHBOARD. I USED PROTECTANTS, ADHESIVES AND DASHBOARD SHADES AND A DASH PAD TO PREVENT FURTHER SPREAD TO NO AVAIL. DURING ONE EVENING TRIP,I HIT A BUMP IN THE ROAD AND THE ENTIRE DASH CAVED IN CAUSING THE INSTRUMENT CLUSTER TO LOSE LIGHTING. I HAD TO COLLECT ALL THE EXTREMELY SHARP SHARDS OF PLASTIC OUT OF THE DASHBOARD RECESS TO LOOK FOR THE PROBLEM. IT WAS DURING THIS INCIDENT THAT A EXTREMELY SHARP PIECE OF PLASTIC CUT DEEP INTO MY RIGHT HAND. I SHOULD HAVE GOTTEN STITCHES, BUT USED GAUZE AND WRAP UNTIL HEALED. WHAT WOULD HAVE HAPPENED IF THE AIRBAG WAS DEPLOYED WITH LOOSE PLASTIC PARTS FLYING ALL OVER THE PLACE? SURVIVE THE CRASH AND THEN DIE FROM MASSIVE LACERATIONS FROM BROKEN DASH PIECES? I CONTACTED MULTIPLE LOCAL DODGE DEALERS AND WAS TOLD THAT THEY KNEW AND CORPORATE KNEW OF THE PROBLEM, BUT THEY WOULD NOT REPLACE IT BECAUSE DODGE CORPORATE WOULD NOT AUTHORIZE OR PAY FOR THE OBVIOUS MANUFACTURING DEFECT. I PROBABLY WILL NEVER BUY A DODGE AGAIN. DODGE KNEW THIS WAS A BIG PROBLEM, BUT DID AND STILL DOES NOT CARE. ALMOST EVERY DODGE I'VE SEEN WITHIN THE 2000-2003 YEARS HAS THIS BLARING PROBLEM. SOME HAVE REPLACED THE DASH WITH AFTERMARKET PARTS OR JUST TRY TO COVER IT UP WITH DASH PADS OR MATS. DOES THE NHTSA CARE? HAS THIS MASSIVE ISSUE EVEN LOOKED INTO? *TR

BOUGHT A 2001 DODGE QUAD CAB SPORT 4X4 IN 2003. THE DASH HAD A SMALL CRACK ON THE DRIVERS SIDE AT TIME OF PURCHASE. THE CRACK SPREAD RAPIDLY TO ALL AREAS OF THE DASHBOARD. I USED PROTECTANTS, ADHESIVES AND DASHBOARD SHADES AND A DASH PAD TO PREVENT FURTHER SPREAD TO NO AVAIL. DURING ONE EVENING TRIP,I HIT A BUMP IN THE ROAD AND THE ENTIRE DASH CAVED IN CAUSING THE INSTRUMENT CLUSTER TO LOSE LIGHTING. I HAD TO COLLECT ALL THE EXTREMELY SHARP SHARDS OF PLASTIC OUT OF THE DASHBOARD RECESS TO LOOK FOR THE PROBLEM. IT WAS DURING THIS INCIDENT THAT A EXTREMELY SHARP PIECE OF PLASTIC CUT DEEP INTO MY RIGHT HAND. I SHOULD HAVE GOTTEN STITCHES, BUT USED GAUZE AND WRAP UNTIL HEALED. WHAT WOULD HAVE HAPPENED IF THE AIRBAG WAS DEPLOYED WITH LOOSE PLASTIC PARTS FLYING ALL OVER THE PLACE? SURVIVE THE CRASH AND THEN DIE FROM MASSIVE LACERATIONS FROM BROKEN DASH PIECES? I CONTACTED MULTIPLE LOCAL DODGE DEALERS AND WAS TOLD THAT THEY KNEW AND CORPORATE KNEW OF THE PROBLEM, BUT THEY WOULD NOT REPLACE IT BECAUSE DODGE CORPORATE WOULD NOT AUTHORIZE OR PAY FOR THE OBVIOUS MANUFACTURING DEFECT. I PROBABLY WILL NEVER BUY A DODGE AGAIN. DODGE KNEW THIS WAS A BIG PROBLEM, BUT DID AND STILL DOES NOT CARE. ALMOST EVERY DODGE I'VE SEEN WITHIN THE 2000-2003 YEARS HAS THIS BLARING PROBLEM. SOME HAVE REPLACED THE DASH WITH AFTERMARKET PARTS OR JUST TRY TO COVER IT UP WITH DASH PADS OR MATS. DOES THE NHTSA CARE? HAS THIS MASSIVE ISSUE EVEN LOOKED INTO? *TR