2001 CHEVROLET TRACKER — Problems, Recalls & Safety Data

The contact owns a Graco Safety Seat, Model Number: 2203450, Model Type: N/A manufactured 04/11/2024. The contact stated that the safety seat was being used in a 2001 Chevrolet Tracker. The contact stated that while attempting to remove her [XXX]granddaughter from the safety seat, the chest clip was stuck and failed to release from the chest buckle, causing the contact to maneuver and to slide her granddaughter out of the safety seat. The manufacturer was not notified of the failure. The safety seat was not replaced. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

INSIDE TIE ROD END DO NOT LINE UP PROPERLY WITH OUTSIDE TIE ROD ENDS ARE FINE AND IN A SHARP TURN IT CAUSE THE FRONT TO SHAKE VERY BAD I CAN LIFT 300 LB AND IT TOOK EVERYTHING I HAD TO CONTROL IT FROM ROLLING OVER. MECHANIC SAID I MUSCLED THE METAL IN TO PLACE AND DAMAGE BOTH INSIDE TIE RODS ENDS ONLY. I HAVE NO REPLACED THEM YET NOT SURE WHAT TO DO. I IF I HAD NOT BEEN STRONG ENOUGH TO BEND THE MEDAL THERE WOULD HAVE BEEN A WRECK. I BEEN KNOW BREAK AND BEND PARTS LIKE THIS BEFORE.

PASSENGER FRONT LOWER CONTROL ARM MOUNTING BRACKET HAS DETACHED FROM THE FRONT CROSSMEMBER. HAPPENED TODAY MARCH 28TH 2017. VEHICLE WAS ORIGINALLY SOLD AND DRIVEN IN NORTH MISSOURI. DOES HAVE CONSIDERABLE RUST, BUT DIDN'T KNOW THE SUSPENSION MOUNTING POINT WOULD BREAK FREE? I WAS A FEW BLOCKS FROM MY RESIDENCE WHEN IT HAPPENED AND NO INJURIES OCCURRED. IT HAPPENED ON NORTH SIDE DR. IN FORT WORTH,TX. OVERCAST, DRY PAVEMENT ON TRAFFIC. I HIT BUMPS ON RAILROAD CROSSING AND QUITE A FEW POTHOLES.

TL* THE CONTACT OWNS A 2001 CHEVROLET TRACKER. WHILE DRIVING AT APPROXIMATELY 35 MPH, OIL LEAKED FROM THE VEHICLE. THE CONTACT ALSO NOTICED WHITE SMOKE COMING FROM THE ENGINE AND SMELLED A STRONG OIL ODOR. THE FAILURE RECURRED NUMEROUS TIMES. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 94,000. UPDATED 02/12/16*LJ THE CONSUMER STATED THE VALVE COVERS LEAKED OIL ONTO THE EXHAUST AND CAUSED SMOKE TO EMIT FROM THE ENGINE. UPDATED 03/07/16.*JB

MY MECHANIC ADVISED ME THAT THE FRONT SUSPENSION CROSS MEMBER IS RUSTED TO THE POINT THE IT WILL SNAP OFF. WHEN I MAKE A RIGHT HAND TURN OR GO OVER BUMPS I CAN HEAR CRACKING NOISES. CONTACTED CHEVY (GM) WAS ADVISED THAT I AM 4 YEARS TOO LATE IN CONTACTING THEM. ASKED ABOUT THE RECALL, THEY TOLD ME IT WAS A SILENT RECALL. AND BECAUSE I LIVE IN A STATE THAT HAS SNOW AND ICE THIS CONTRIBUTED TO THE PROBLEM. I ADVISED THAT IS THIS IS THE CASE THEN EVERY CAR IN THIS STATE WOULD HAVE THE SAME PROBLEM. FOLLOWING IS FROM GM'S WEBSITE: " FRONT SUSPENSION CROSS MEMBER DID NOT RECEIVE ADEQUATE CORROSION PROTECTION. THE RESULT OF THIS CONDITION MAY BE MOST NOTICEABLE ON VEHICLES DRIVEN IN AREAS WHERE RUST IS MOST COMMON, SUCH AS AREAS WHERE SALT IS USED TO CONTROL SNOW AND ICE. THE CORROSION MAY ADVANCE AND CAUSE RUST-THROUGH PERFORATION OF THE CROSS MEMBER IN THE AREA OF THE LEFT OR RIGHT FRONT LOWER CONTROL ARM ATTACHMENT BRACKETS. AS THE CORROSION PROGRESSES THE CROSS MEMBER WILL BECOME THINNER AND THE ATTACHMENT BRACKETS AND THE PERFORATIONS WILL GROW IN SIZE. IF THERE ARE SUBSTANTIAL AMOUNT OF PERFORATIONS, THE LEFT AND RIGHT FRONT LOWER CONTROL ARM ATTACHMENT BRACKETS WILL BECOME WEAKENED AND BEGIN TO FLEX. IF THIS OCCURS, THE CUSTOMER MAY NOTICE FRONT TIRE WOBBLE, STEERING LOOSENESS, VEHICLE PULL TO ONE SIDE, FRONT END NOISES (CLUNK, BANG, RATTLE, ETC) VEHICLE SHAKING, OR STEERING WHEEL ROTATION WHEN SHIFTING FROM REVERSE TO DRIVE AND DRIVE TO REVERSE.