2012 BMW R 1200 R Power Train Problems

FUEL LEAK FROM BROKEN PLASTIC "QUICK DISCONNECT" FITTING ON THE LEFT SIDE OF THE MOTORCYCLE. I NOTICED THE ISSUE WHEN I WAS RIDING THE MOTORCYCLE ON THE HIGHWAY AND RAW FUEL WAS SPRAYING ONTO MY LEG AND ONTO THE CYLINDER & CYLINDER HEAD OF THE ENGINE. I PULLED OFF THE HIGHWAY INTO A GAS STATION TO DETERMINE THE SOURCE OF THE LEAK. AFTER REMOVING SOME PLASTIC TRIM/COVERS I FOUND THE SOURCE WAS THE PLASTIC 90 DEGREE FITTING HAD CRACKED. THE FUEL FITTING DID NOT FAIL DUE TO ANY IMPACT, TAMPERING OR ABUSE; IT IS IN A PROTECTED AREA AT THE LOWER EDGE OF THE FUEL TANK AND COVERED BY A PIECE OF PLASTIC TRIM. AFTER INSPECTING THE FAILED PART, I NOTICED HOW THIN THE PLASTIC IS AND HOW IT BROKE ON THE GROOVE (A STRESS RISER). I BELIEVE THE PART IS POORLY DESIGNED AND POSES A SERIOUS SAFETY AND FIRE...

STALLING ENGINE. I BOUGHT THE MOTORCYCLE NEW AND IT HAS HAD A STALLING PROBLEM SINCE IT WAS NEW AND CONTINUES UNTIL TODAY. THE ENGINE WILL STALL AT IDLE OR ON DECELERATION. AT ITS WORST IT WILL HESITATE AND SURGE WHEN ACCELERATING FROM A STOP AS WELL. I HAVE COMPLAINED TO THE DEALER ABOUT THE ISSUE AND HAVE NOT HAD ANY RESOLUTION TO THE PROBLEM. I MADE A COMPLAINT TO BMW CORPORATE REGARDING THE UNRESOLVED ISSUE AND PRESSURE WAS PLACED ON THE DEALER TO FIX THE PROBLEM BUT THE PROBLEM PERSISTED AND THE DEALER EXPRESSED THEIR DISMAY WITH MY COMPLAINT TO CORPORATE. I PAYED FOR REPAIRS (WHILE UNDER WARRANTY) THAT DID NOT SOLVE THE STALLING PROBLEM. NOW THE MOTORCYCLE IS OUT OF WARRANTY AND I DO NOT HAVE THE FINANCIAL MEANS TO KEEP FORKING MONEY OVER TO THE DEALER SERVICE DEPARTMENT FOR NO RESULTS. I TRIED GOING THROUGH THE NORMAL CHANNELS...