NHTSA Complaint #11663536 — 2016 TESLA MODEL X

The following is copied from: NHTSA ID Number: 11487520 Incident Date [XXX] Consumer Location SAN JOSE, CA On nine separate documented occasions, the passenger front wheel molding trim piece, in which one of the proximity sensors is mounted, completely detached, causing the proximity sensor to alarm continuously. On two of these nine occasions, the trim piece detached while the vehicle was traveling on the road, and on one of these two occasions, the vehicle was traveling on the highway at highway speeds. On this occasion, after detaching completely, the trim piece was observed through the rear view and side mirrors, shattering on the road and scattering debris across the highway, potentially causing a traffic hazard for the cars following. On this last occasion, the vehicle was also traveling with the assistance of the Adaptive Cruse Control and Forward Collision Warning features, which both caused the vehicle's emergency avoidance systems to activate when the proximity sensor was falsely triggered. If there were other vehicles nearby, this could have caused a high speed accident as my vehicle executed both an emergency braking and collision avoidance maneuver for no real reason. Please note that I have documented reports of the possible safety issues due to the wheel well trim detaching to the Tesla service department for several of the times I've had the vehicle in for repair. In all nine instances, I've been told that my vehicle is the only one that exhibits this problem. A statement I find difficult to believe as I have observed other vehicles of the same make and model driving around without the trim pieces, and just recently captured a photograph of a Model X driving on the highway with the trim piece detaching as the wind was catching it. See the red arrow in the photograph attached below. This report adds two additional photographs of the same issue that have been taken since the original report was filed.