NHTSA Complaint #11619482 — 2014 FORD FUSION

I've had my Ford Fusion SE ecoboost 1.5, 2014 in for service on 2 separate occasions a day apart for the same reoccurring problems. The first service there was the actions done related to recalls which are consistent with 20S15 A-C and recall 23E03 B. The reasons for my Ford Fusion 1.5 to have been brought to the Premier Ford, Waveland, Ms was as follows: The temperature overheat lamp light was jared, there was 3 leaks from the overheat, there was a Shutter and sounds that came from the engine, (LIMP*)and there was no fuel power through acceleration. There had been moisture located on exhaust before brakedown without having been driven for approximately 10hrs before brakedown. 2ed service was as follows: temperature overheat lamp light jared, no power through fuel to accelerate, and issues starting. LIMP* I had not on this brakedown paid attention to if my Fusion needed water, the engines performance in regards to shakes or sounds nor did I look to notice nor did I look for leaks. I called directly to Premier Ford, Waveland and had my Ford towed in. The service was as follows: 1) 3U2Z*14S411*HYB WPT988 WIRE ASY 2) DS7Z*8501*E PW556 PUMPASP-WATER 3) BE8Z*8507*A GASKET-WATER PUMP 4)VC*13*G 3801132 ANTI-FREEZE 5) 6 BM5Z*6K2543*S437 SCREW 6) BM5Z*6K254*A TENSIONER - TIMING BELT With the parts 261.44 Labor 1748.99 misc charges 50.00 for a total of after taxes 2204.66 I picked up my Ford Fusion on October 4, 2024 and on October 9, 2024 I went beck to the Premier Ford and spoke with the service department because I had to stop and let my Fusion cool every 20 to 30 minutes, I stated that there was some loss of water and it was overheating, the power train light warning notify me of an issue, and that my Fusion would not go over 80miles per hr. The service department associate seemed frustrated with me and argued the fact that it had ran hot and said that the reason for the speed issue was that the lamp was Identifying the keylock complete on pdf