NHTSA Complaint #11614896 — 2013 HYUNDAI VELOSTER

A connecting rod bearing failed in the engine leading to catastrophic engine failure with the connecting rod breaking through the wall of the engine block causing a hole and undriveable vehicle. According to my research, this issue has been recalled in adjacent model years (2015-2016) but not in my model year (2013) that has the same engine. This issue has already been confirmed in these engines, but Hyundai states my car is not included in the recall. This was a safety risk because the engine failure breached the engine wall which could have ignited engine oil and caused a fire. The engine may have also failed at a critical driving moment when acceleration was needed and stranded the car in an unsafe position. Yes, the problem was reproduced at the dealer's service center because the failure occurred while they were test driving my vehicle. Since the service center tech was the one driving the car when the incident occured, I do not know if there was a fire or not and the speed they were traveling, etc. The vehicle has been inspected by the dealer service center and confirmed that this is the issue that caused the problem. The dealer even suspected this was going to happen as they had foreknowledge of the issue occurring on other vehicles that had already been recalled for this issue. The only prior warning of this issue is that I had some misfires on the engine a few days before which is what prompted me to bring it in for service. The misfires temporarily illuminated the "check engine" light but then the light went back out again. I had no idea this minor issue would result in such a severe, catastrophic failure.