NHTSA Complaint #11555261 — 2022 JEEP WRANGLER

Installed a factory Jeep Fox 2" lift kit after reaching 700 miles on new 2022 Sahara. Checked and rechecked all torque specifications and took to dealer the next day for an alignment. They straightened the steering wheel which is a normal requirement when installing a lift. After about one month, I had an occurrence of the "death wobble". This is my 5th Jeep Wrangler, some with lifts, some without, so I am aware of the wobble when hitting a bump around 50-55mph and how to handle it. I rechecked all the specs on each bolt touched during lift install. I don't drive it much and baby it so it took a while before it happened again. Last week, 3 time on same highway around 55mph ON A STRAIGHT highway I experienced the wobble. I found a great diagnosis blog which led to the discovery of both tie rod ends failing and making 'clunking' noise man manually twisted by hand. I took to the dealer who had to order parts. There was no mention of stock tire balancing or steering damper replacement like in other complaints, however I have not recieved my Jeep back yet to verify the problem is fixed. Everything on the vehicle is stock other than the Mopar/Fox lift kit from the dealer. I requested another alignment and I'm curious to see the numbers compared to 1 year ago. The camber and caster is not adjustable and the tires were rotated once already and only have about 8700 miles on them. The obvious culprit I found as a consumer was the tie rod ends which have been described in many Jeep forums as being sub-par and junk. If my wife would drive this Jeep with my two young children and experienced the wobble for the first time on her own, there is no doubt she could crash into a fellow motorist. I always have to slow down and pull to the shoulder....I'm not sure how she'd react. Dangerous and noted multiple times on this site and Jeep forums. Make JEEP fix this issue as it has been around for YEARS!