NHTSA Complaint #11533946 — 2016 FORD ESCAPE

At about 57,200 miles, the NHTSA Safety Recall 22S43 - North America Non-FSA Multi Vehicle Line Shifter Cable Bushing was performed by Wright Ford of Redmond, OR. This recall was to prevent detachment of the shifter control line from the transmission. On July 17, 2023 at about 58,900 miles, the shift control line detached from the transmission. Thus, the exact scenario the recall was intended to prevent/fix, occurred about 1,600 miles after the work was completed by Wright Ford. The shift control line was then repaired by [XXX] Auto Repair of Baker City, OR. He said the shifter had become completely disconnected but that the parts were still intact and he was able to reconnect. He could see no reason for this disconnect to have occurred. This suggests that (1) the recall fix did not work, or (2) the recall fix work was done incorrectly by the local Ford dealer, or (3) the replacement parts from Ford were defective. There were no initial warnings other than while driving at about 25 mph we were unable to shift from S to D mode. Once we came to a full stop and turned off the engine, the shifter was moved to P. However, it would not then move to any other position. Attempts to start the engine gave a warning that the vehicle was not in Park. The brake-shift interlock reset, hidden under the shift bezel, was used to release the shifter and move it to the N position for towing 25 miles to a repair shop. The repair shop successfully reconnected the shift line at the transmission and thereafter the vehicle was able to be driven. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)