NHTSA Complaint #11483816 — 2016 SUBARU FORESTER

Passenger commented, asking why their seatbelt attachment point was not properly anchored and was hanging loose from front seat. Upon investigation, we noticed that the bolt holding the end of the LH portion of the passenger seatbelt had backed out. We were able to make a temporary field repair by tightening the bolt back in with our fingers, and later needed to use a 17mm wrench to further tighten the bolt to the point where it appeared to be reasonably tightened. When tightening the bolt, I did not notice any type of locking washer, or sense there was any type of chemical locking materials on the threaded portion of the bolt and wonder if it was improperly attached when the vehicle was built. In the case of an accident, I think it is reasonable to assume that the loose bolt would have failed and allowed the anchored end of the passenger seatbelt to come loose. The vehicle has approximately 27,000 miles, has never been in an accident, and has never had seats removed or repaired since we purchased it new.