NHTSA Complaint #11475326 — 2013 FORD FOCUS

My daughter has a 2013 Ford Focus SE and has had numerous issues with her transmission which of recent has presented some serious safety concerns. She had driven her car to work and when attempting to leave after work was unable to get her car to move . She put the car in drive and reved the engine then in reverse the same , would not move. We had the car towed to Sarchione Ford of Alliance and was diagnosed as the Transmission Actuator A . My understanding of the Actuator is it engaged the transmission into gear. I recently read an article in a Ford Forum relating to the April 2020 Class Action Suit and I quote a blogger stated that this defect can abruptly cause car to jump into gear which could cause a safety issue . Another blogger stated that he had a similar issue while on an expressway traveling fast and ended up on the shoulder until eventually getting the car to move again. My daughter's Ford Focus 2013 has had 2 recalls issued relating to the transmission. Program #14M01 Transmission Clutch Shudder / Transmission input seal Warranty extension which is no longer valid. Program #14M02 Transmission Control Module which has been extended to 150,000 mile or until February of next year. Both of the said recalls we're mandated due to the numerous safety concerns relating to failure or uprupt operation due to design defect and no fought of the vehicle operation. So I pose a very simple question, why has not Actuator A and B of the Ford Focus been issued recalls when failure of said parts presents safety concerns? There should be a warranty extension mandate to repair at no cost to vehicle owner. All of these said parts work together when operational to perform safe driving practices on the contrary the motorists are left at risk regarding highway safety. I have written a letter to CEO Jim Farley to reevaluate his Customer Satisfaction Program and recall procedure. The NHTSA needs to review the said safety concerns. I have filed with Ford Motor PAS-37493284.