NHTSA Complaint #11464793 — 2013 MERCEDES-BENZ C300

2013 Mercedes Benz C300 4dr AWD. Corrosion of Rear Sub-Frame (aka "Rear Axle Carrier" or "Suspension Cross Member") (New Part #: 207-350-97-02. Old Part #: 204-350-01-41 + other numbers). Car experienced erratic behavior under all braking scenarios. Extremely dangerous behavior under heavy breaking (65 mph to 25 mph). Life threatening severity of issue. 2 personal experiences. 1: Stopping at a yellow light in a quick fashion (55-0 mph, no abs required), car pulled hard to left and almost pulled me into curbing on left hand side. It felt like the rear end was on ice and was going to do a 180 partial spin. 2: Pulling off a highway into a turning lane and braked hard to slow down for right hand turn (65-15 mph). Car pulled about 8 feet left and almost put me back into full speed traffic. Same uncontrollable "on ice" feeling. I was on a road trip and had car towed to independent mechanic in the town I was visiting. He found holes throughout rear sub-frame member on drivers side and passenger side. Mounting points for suspension components were not structurally sound. He said I was lucky the control arm didn't break loose and puncture the gas tank. Corrosion was limited to sub-frame. The rest of car was "Nearly Perfect" in the words of the mechanic. Called Mercedes Corporate and they advised towing car to local MB dealer for inspection. MB Lancaster determined car was unsafe to drive. I am currently pursuing a good will repair case that has been initially denied. Parts are back ordered for 10+ weeks. I've called several dealers to source the part and nearly dealers have orders placed to Germany for these sub frames. Repair + alignment is approximately 4k USD. In 2018, Mercedes has issued Official Service Information Supplemental Notes (SI35.00-P0009A) to technicians to look for premature corrosion issues. This is free of charge replacement in UK and Germany already and a recall in Canada. US needs to catch up quick before death occurs.