2024 RAM 2500 Power Train Problems

Had to stop urgently, and my truck shut off. I had to shift it into park to get it started again. Was in the middle of a 4 lane section of route one traveling with traffic at the time. I was a sitting duck until I could figure out what happened. (I’m a mechanic, if the average person was dealing with this I don’t know if they would have been able to get moving as quickly.) It acted like the torque converter stayed locked while I came to a complete stop stopping the engine at the same time. No shuddering or anything obvious. Engine wasn’t running when I came to a stop. i only noticed because it was abnormally quiet and didn’t move when I stepped on the throttle. I’ve owned this truck since the end of July 2025, it was a brand new left over 2024, currently has around...

Dealer confimed roller lifter failure on 9/23/25, they replaced the roller lifters, push rods, cam shaft and rocker arms. Within 20 miles of picking up the truckl on 10/11/2025 the same noise the repair was suposed to remedy was back adn the same volume/ intensity as before. The warranty repair did not remedy the issue.

Lifters are failing with 31,000 miles. There are thousands of these trucks with less than 30,000 miles on there second or third set of lifters. I took the truck to Allen Samuels Dodge in Aransas pass Texas for a loud rattling kept the truck several days couldn’t figure it out. I recorded a video of the banging inside the engine they kept the truck 5 days or so gave me a letter saying it’s under investigation and I should call Ram about the lifters. Called Ram they said call the dealer or take it to another dealer. Service guy was like yeah the lifters are failing left n right and locking up the engine. The grid heater bolt is burning off and falling into the number 6 piston on these trucks locking up the engine. I have numerous screen shots from several Ram 2500 groups where people are getting new...

When truck is in drive and I press the brake to shift to reverse, when I take my foot off the brake truck will go forward before reversing. Dealership says there is no problem with it. I find it to be dangerous.

While driving, the truck began to violently shake when downshifting. As I was exiting the highway and braking, the shaking intensified, and the truck stalled while I was traveling around 30 MPH, causing a complete power loss. To avoid a collision, I veered off the ramp and ended up scraping a road sign, which caused damage to the bed above the right fender, the road sign was intact and there was no damage to the sign. When I attempted to restart the truck and placed it in drive, it accelerated on its own. Applying the brakes only made it accelerate further, causing the truck to lunge forward uncontrollably. I managed to slow it down by putting it in neutral, regaining full brake control. I was able to get the truck to my driveway, but as soon as I turned into the driveway, it stalled again. I had to repeat this...

The transmission failed and is available for inspection. The vehicle lost power at 60 mph in an instant as transmission began to slip on a busy road truck would barely move. The problem was reproduced by the dealer and confirmed. Inspection upcoming. Check engine light went on.