2021 KTM 790 ADVENTURE R Engine Problems

The valve train of my bike failed and left me stranded in the woods. There were no signs or warnings beforehand. After further research online, I found that this issue has been happening quite a bit. Luckily it happened to me while my bike was parked. The issue is the valve train is wearing out prematurely and causing the bikes to run poorly or not run at all. My bike has 13,000 miles on it and other bikes have had more or less miles when this issue occurred. I've worked on several motorcycles with three times the miles and never had an issue with the valve trains being chewed up like this current issue. This issue could possibly cause the bike to stop running while it is being driven at whatever speed. A bike suddenly stalling out in traffic isn't the safest scenario for a motorcycle rider. Especially if they're...

I have checked the cam shafts condition at only 3900 miles since there are a lot of people with the same motorcycle mentioning this issue and there is an unsuspected wear starting to happen. Motorcycle always ran on recommended Motorex oil and air filter was maintained as it should be.

Difficult cold start ups. When the bike is cold or has been sitting for 1-2 weeks and I start it up intermittently the bike has problems starting up and running. Will stall out and need to attempt to restart it several times before it will run. Appears to be running on a single cylinder for 30-45 seconds when it does finally start up then will run as normal. This does not occur when the motorcycle is already warm. Concerned about possible mechanical damage from running on a single cylinder which could be dangerous on a motorcycle and result in injury.

Motorcycle hard/impossible to start. Excessive valve wear. Currently unrideable due to mechanical problems. Motorcycle stalled at intersection of busy highway, would not start creating hazard of being hit in the intersection and while pushing it to side of road. Mechanic inspected vehicle, found excessive wear to valvetrain causing engine power loss and stalls. States that it appears to be a manufacturing defect in the intake system allowing dirt ingestion leading to excessive irreparable valve wear.

The motorcycle is having a cold start issue. When starting after 24hours, the motorcycle will not start right away or will only start on one of two cylinders. After roughly 60 seconds the second cylinder starts up.

When I start the bike, it sounds like the engine is only running on one cylinder and misfiring. It runs 'rough' like this for about 30 -60 seconds and the revs are sitting between 1000-1300 instead of the normal 1300-1500rpm range. You can smell fuel while this is happening. It then 'pops' and the engine runs fine after that. I live in the Netherlands, but wanted to register the issue here as well for investigation.

When engin is cold for more then 8 hours. Engin will start only on 1 cylinder (right), for +/- 1 minute (1000 +/- rpm), after, you will heard internal explosion, and left cylinder will start (1600 +/- rpm) . and dropping at 1400 for normal idle. With an strong gazoline smells after start-up, after 2 3 minutes smeel is gone Please note that I live in Canada Quebec

The motorycle has a hard time to start. At times throttle needs to be added to keep the engine from dying out. A modern and fuel injected bike should not need to have the throttle be opened for the bike to start up.

Stalled dozens of times and sudden loss of power when cold

I just wanted to make you aware of my 2021 KTM 890 R VIN # [XXX] 2000 MILES Since new it has had a hard start when cold or sitting overnight. It takes 2 or 3 times to start and keeps stalling I stalls runs rough and even runs on one cylinder for 30 to 60 seconds. Its a 2 cylinder motorcycle. Once running it runs great rest of day. MANY folks are seeing the same condition and KTM is not responding with anything of a solution I have owned many many motorcycles and even 6 KTMS but their lack of attention here is not good. Dealers say it's normal or no problem found. My local dealer said yeah, we have seen it no real fix. The earlier 2019/2020 790 models had hard start issues but this new 2021 890 model is worse, more widespread and more severe— running on...

Starting immediately after the mandatory 600 mile service check by an authorized KTM dealer, this vehicle started experiencing prolonged cold start failures. It went from starting 100% of the time after three or less start attempts to requiring approximately ten failed start attempts before starting and running. Until 10/20/21, this motorcycle has always been fueled with either 93 octane gasoline with 10% alcohol or 90 octane fuel with no alcohol (only 2-3 times) as recommended by the manufacturer. On 10/20/21, I filled the nearly empty fuel tank with 87 octane, 10% alcohol. On the next overnight cold-soak starting attempt, and every cold start following, the vehicle started immediately on the first start attempt and settled immediately into a normal fast idle until warmed-up. This vehicle was purchased new with 0 miles on June 11, 2021. It received it's 600 mile manufacturer-required service at approximately 680 miles in September, 2021. It...