2003 FORD MUSTANG Engine Problems

THE EXHAUST PIPE BREAKS WHERE THE A/C WATER DRIPS. THIS IS DUE TO POOR DESIGN OF THE CAR. THIS ARTICLE DESCRIBES IT BETTER. HTTPS://FORD.OEMDTC.COM/100/EXHAUST-LEAK-CRACKED-OR-SEPARATED-RIGHT-SIDE-EXHAUST-PIPE-1999-2004-FORD-MUSTANG

TL* THE CONTACT OWNS A 2003 FORD MUSTANG. THE CONTACT STATED THAT THE VEHICLE EXPERIENCED A LOSS OF POWER. UPON INSPECTION, THE CONTACT DISCOVERED THAT THE SPARK PLUG WAS MISSING FROM THE ENGINE COMPARTMENT. WHILE TIGHTENING BOLTS IN THE ENGINE COMPARTMENT, THE VEHICLE EJECTED ANOTHER SPARK PLUG. THE VEHICLE WAS TAKEN TO HOLLINGSWORTH RICHARDS FORD WHERE THE CONTACT WAS NOTIFIED THAT THIS WAS A KNOWN ISSUE WITH THIS VEHICLE. SINCE THERE WAS NO RECALL, THE ENGINE HEAD CYLINDER WOULD NEED TO BE REPLACED. THE MANUFACTURER STATED THAT, DUE TO THE MILEAGE OF THE VEHICLE, THE CONTACT WOULD BE RESPONSIBLE FOR THE REPAIR COST EVEN THOUGH THIS WAS A KNOWN ISSUE WITH THIS MODEL VEHICLE. THE FAILURE MILEAGE WAS APPROXIMATELY 167,000.

WE HAVE HAD ISSUES WITH THIS CAR SINCE IT WAS BOUGHT NEW. ALL ISSUES HAVE BEEN LOOKED AT BY THE DEALER DURING THE FACTORY WARRANTY AND STILL REMAIN UNRESOLVED. I HAVE WRITTEN A LETTER TO FORD HEADQUARTERS BUT THEY SENT A COMPLETE REJECTION LETTER. I WAS TOLD TODAY BY A FORD CUSTOMER SERVICE REPRESENTATIVE TO FILE A COMPLAINT HERE. I CAN SUPPLY DOCUMENTS AND THE ORIGINAL LETTER TO FORD IF NEEDED. THE MAIN ISSUES FROM PURCHASING NEW AND DRIVING OFF THE LOT ARE (IN ROUGH ORDER OF IMPORTANCE): -MAJOR PAINT AND CLEAR COAT ISSUES (BROUGHT TO DEALER TWO DAYS AFTER PURCHASE TO COMPLAIN. THEY HAVE NEVER RESOLVED PROBLEM AND IT HAS CONTINUED TO GET WORSE TO THIS DAY.) -DRIVER DOOR WINDOW STOPS WORKING INTERMITTENTLY. -CAR ENGINE SURGING MAKING CAR LURCH FORWARD (MY WIFE WAS INVOLVED IN A MINOR ACCIDENT BECAUSE OF THIS. IT WAS REPORTED TO INSURANCE.) -ENGINE ACTS LIKE...

WHILE DRIVING MY VEHICLE ON THE INTERSTATE I HEARD WHAT I THOUGHT WAS A POPPING SOUND AND THEN EXPERIENCED A LOSS OF POWER. I EXITED OFF THE INTERSTATE AND BEGAN DRIVING AGAIN. MY VEHICLE FELT AS IF MY TORQUE CONVERTER WAS SLIPPING AND THAT POWER WAS REDUCED FROM THE MOTOR. I TOOK MY VEHICLE TO MY LOCAL SERVICE MECHANIC WHO ADVISED ME THAT THE 3RD CYLINDER SPARK PLUG HAD SOMEHOW BACKED ITSELF OUT OF THE CYLINDER HEAD WHICH WAS CAUSING A LOSS OF POWER TO THAT CYLINDER. IT ALSO WAS STILL RECEIVING POWER VIA THE COIL PACK WHICH IN TURN MELTED THE RUBBER BOOT AND FRIED THE COIL PACK FOR THAT CYLINDER. THE RUBBER FROM THE BOOT RAN DOWN INTO THE SPARK PLUG AND FILLED THE HOLE. I HAD TO REPLACE BOTH THE PUG BOOT AND COIL PACK FOR THE 3RD CYLINDER ALONG WITH THE LABOR OF REMOVING MELTED RUBBER...