1985 FORD E350 — Problems, Recalls & Safety Data

Recall 89V139000 — VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:HEATER CORE

November 6, 1989 | 500 vehicles affected

Defect: HEATER HOSE MAY BE INCORRECTLY ROUTED.

Consequence: HOSE COULD WEAR THROUGH AND LEAK WHICH COULD RESULT INAN UNDERHOOD FIRE.

Remedy: REROUTE AND REPAIR HOSE, AS NECESSARY.

Recall 89V140000 — VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:HEATER CORE

September 1, 1989 | 2,700 vehicles affected

Defect: HEATER HOSE MAY BE INCORRECTLY ROUTED.

Consequence: HOSE COULD WEAR THROUGH AND LEAK WHICH COULD RESULT INAN UNDERHOOD FIRE.

Remedy: REROUTE AND REPAIR HOSE AS NECESSARY.

Recall 89V062000 — ELECTRICAL SYSTEM:WIRING

June 1, 1989 | 228 vehicles affected

Defect: NYLON TIES THAT SUPPORT THE MAIN WIRING HARNESS TO THE CHASSIS COULD WEAR AND BREAK DUE TO EXCESSIVE VIBRATION. THUS, WIRING HARNESS COULD FALL ON ENGINE COMPONENTS AND SHORT CIRCUIT.

Consequence: THIS COULD CAUSE LOSS OF ELECTRICAL SYSTEM WHICH COULDRESULT IN AN UNDERHOOD FIRE.

Remedy: INSTALL RETROFIT RIT OF PLASTIC-COATED METAL CLAMPS, LOOM FOR POSITIVE BATTERY CABLES AND RE-ROUTE WIRING.

Recall 88V133000 — ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS

September 14, 1988 | 14,975 vehicles affected

Defect: EXTREME OPERATING CONDITIONS COULD CAUSE PREMATURE DETERIORATION OF THE ENGINE COMPARTMENT HEATER HOSES OR ENGINE BYPASS HOSES.

Consequence: ENGINE COOLANT COULD DISCHARGE ONTO THE ENGINE AND ITSEXHAUST MANIFOLD CREATING THE POTENTIAL FOR A FIRE DUE TO THE HIGH ENGINEEXHAUST MANIFOLD TEMPERATURES.

Remedy: REPLACE HOSES AND RADIATOR CAPS; INSTALL HIGH HEAT RESISTANCE ALUMINIZED STAINLESS STEEL MUFFLERS.

Recall 87V144000 — ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL

February 3, 1988 | 188,000 vehicles affected

Defect: VEHICLES ARE SUBJECT TO EXCESSIVE UNDERHOOD TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS.

Consequence: THIS CREATES POTENTIAL FOR FUEL EXPULSION FROM THE FUELFILLER PIPE WHICH IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN AFIRE.

Remedy: INSTALL MODIFICATION KITS TO MINIMIZE POSSIBILITY OF FUEL EXPULSION AND TO SHIELD UNDERBODY COMPONENTS FROM EXHAUST SYSTEM HEAT.

Recall 87V113000 — ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:EMISSION CONTROL

July 14, 1987 | 16,000 vehicles affected

Defect: EXPULSION OF FUEL DUE TO OVERPRESSURIZATION.

Consequence: FUEL OR FUEL VAPORS IN THE PRESENCE OF AN IGNITIONSOURCE CAN CAUSE A FIRE.

Remedy: MODIFICATION OF THE BASE FUEL VENTING AND EMISSION CONTROL SYSTEM TO REDUCE OPERATING TEMPERATURES AND FUEL SYSTEM PRESSURES.

Recall 87V111000 — FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY:MOUNTING

July 2, 1987 | 250 vehicles affected

Defect: FUEL LEAK AT THE TOP OF THE FRONT FUEL TANK IN THE AREA OF THE VAPOR VALVE GROMMET. GROMMET MAY SPLIT DUE TO COMPRESSIVE LOAD WHEN INSTALLED IN THE FUEL TANK.

Consequence: FUEL MAY LEAK FROM VAPOR VALVE AND BECOME THE SOURCE OFFUEL FOR A FIRE.

Remedy: INSTALLATION OF A NEWLY DESIGNED VAPOR VALVE GROMMET.

Recall 86V092000 — POWER TRAIN:DRIVELINE:DRIVESHAFT

July 16, 1986 | 2,100 vehicles affected

Defect: COMPOSITE GRAPHITE DRIVESHAFTS ARE SUBJECT TO OVERHEATING WHILE IDLING, WHICH MAY RESULT IN THE DRIVESHAFT TWISTING AND SHORTENING CAUSING THE SLIP YOKE TO DISCONNECT FROM THE TRANSMISSION. CONSEQUENCE OF DEFECT: IF THE DRIVESHAFT DISCONNECTS FROM THE TRANSMISSION THE VEHICLE WOULD BECOME IMMOBILE WITHOUT WARNING.

Remedy: INSTALL METAL DRIVESHAFT.

Recall 86V094000 — STEERING:LINKAGES:DRAG:LINK:CONNECTION

July 16, 1986 | 70,125 vehicles affected

Defect: THE RUBBER THAT ENCASES BALL STUD AND SOCKET JOINT (CONNECTS STEERING DRAG LINK AND PITMAN ARM) MAY DETERIORATE, CAUSING METAL TO METAL CONTACT, AND MAY EVENTUALLY RESULT IN COMPLETE SEPARATION. CONSEQUENCE OF DEFECT: COMPLETE SEPARATION OF THE DRAG LINK TO PITMAN ARM CONNECTION RESULTS IN LOSS OF STEERING CONTROL WHICH MAY LEAD TO AN ACCIDENT.

Remedy: INSTALL NEW DRAG LINK ASSEMBLIES WITH STEEL BALL AND SOCKET JOINTS AT THE PITMAN ARM CONNECTIONS.

Recall 85V061000 — FUEL SYSTEM, DIESEL

| 8,500 vehicles affected

Defect: WHEN FRONTALLY IMPACTED INTO A FIXED BARRIER AT 30 MPH, AS SPECIFIED IN FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 301, THE LEFT FRAME RAILS OF SUCH VEHICLES MAY DISPLACE INBOARD, PINCHING THE FUEL/WATER SEPARATOR CANISTER BETWEEN THE FRAME RAIL AND ENGINE SUFFICIENTLY TO DISPLACE THE FUEL/WATER SEPARATOR DRAIN ROD, ALLOWING THE CONTENTS OF THE CANISTER TO DRAIN. CONSEQUENCE OF...

Remedy: INSTALL A CANISTER SHIELD, A REVISED DESIGN DRAIN ROD SHIELD, AND MODIFY FUEL/WATER SEPARATOR MOUNTING BRACKET.