2024 FORD BRONCO — Problems, Recalls & Safety Data

The contact owns a 2024 Ford Bronco. The contact stated that while driving approximately 65 MPH, the brake warning light illuminated, and the brake pedal needed to be depressed with more force. The contact stated that the brake pedal was soft and there was no pressure on the pedal. The vehicle was taken to the residence. The vehicle was then taken to a dealer, where it was diagnosed and determined that the brake vacuum hose was leaking and needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 48,000.

I am writing regarding my new Ford Bronco vehicle, VIN: [XXX] , purchased in November 2024, currently with 7,151.5 km. I recently received Ford’s official notice advising that the engine block heater in this vehicle may develop a coolant leak which could result in an electrical short circuit when the system is plugged in. This is a serious manufacturing and safety defect that existed at the time of sale. Due to the nature of this hazard, I am not operating the vehicle, as it has been placed it on storage insurance. The vehicle has not been driven since receiving Ford’s notice in order to mitigate risk and prevent potential damage or injury. Under Manitoba’s Consumer Protection Act and the Sale of Goods Act, a new vehicle must be of acceptable quality, safe, durable, and fit for its ordinary purpose. A vehicle delivered with an admitted safety defect fails to meet these legal requirements. Accordingly, I am formally exercising my right to rescind the sales contract and cancel the related financing agreement. I am kindly requesting a full buy-back, including refund of all payments made to date, payoff of the remaining loan balance by Ford or the dealer, and the cancellation of the financing agreement with no negative credit impact. I would appreciate a written response from you within five (5) business days so that we may proceed toward a timely and appropriate resolution. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2024 Ford Bronco. The contact stated that while driving the vehicle at night, the headlights failed to provide adequate illumination and created a visibility hazard for the driver. While inspecting the vehicle, the contact discovered that there was condensation inside the front headlight assemblies, which caused the illumination from the headlights to be reduced. The contact indicated that the failure occurred while the temperature was below 50 degrees. The cause of the failures was not yet determined, and the vehicle was not repaired. The manufacturer and the local dealer were notified of the issue. The failure mileage was 3,500.

While driving on the interstate in light snow and mostly clear and semi dry roads, ice accumulates on both the head lights and the foglights to a degree that they no longer project enough light to see far enough ahead at even moderate speeds. When I pulled over to inspect them, the surface was coated with a mix of ice and dirt rendering them useless. Ambient temperatures were between 24 and 30 degrees. It seems that the LED lights lack enough heat to protect from ice accumulation and a heat element of some type should have been included given the placement of the lights being somewhat recessed and that allows for accumulation. Obviously in pre-dawn darkness this produced an unsafe operation of a vehicle at highway speeds due to not being able to see the road far enough in advance. As far as I know it has not been addressed or noticed by Ford since there is no information about this in their manual. I have seen aftermarket products that heat the light surface and prevent the accumulation of ice - Ford should retrofit something to prevent the accumulation of ice on light surfaces.

The contact owns a 2024 Ford Bronco. The contact stated that while the defroster was engaged, the windshield cracked on the driver’s side. The crack started at the bottom of the windshield and spread to approximately 7-inches. The contact had not taken the vehicle to a local dealer or a glass repair shop to be repaired. The vehicle was not diagnosed or repaired. The contact researched online and related the failure to an issue with the OEM windshield. The manufacturer was not informed of the failure. The failure mileage was approximately 3,000.