2003 DODGE RAM QUAD CAB Structurebody Problems

2003 DODGE RAM QUAD CAB 4X4 HAD VEHICLE TOWED AND WHEN TOW TRUCK DRIVER HOOKED CHAINS TO FRAME RAILS TO WINCH VEHICLE ON TO TOW TRUCK THE CHAINS RIPPED THE STEEL OUT OF THE BOTTOM OF THE FRAME DO TO THE FRAME BEING ROTTED I HAVE UPLOADED PHOTOS. THIS IS A REAL SAFETY CONCERN DO TO THE FACT THE FRAME IS ENCLOSED AND THERE IS NO REAL WARNING OR SIGNS OF THE INTEGRITY OF THE REMAINING STRUCTURE OF THE FRAME. IT IS IN MY OPINION THIS NEEDS TO BE ADDRESSED AND FRAME SHOULD BE RECALLED THERE ARE MANY OTHER PEOPLE WITH THE SAME TRUCKS EVEN A LOT NEWER THAN THIS ONE BUT SAME FRAME AS MINE AND THE SAME PROBLEM THERE IS NO REASON OTHER THAN POOR ENGINEERING AND PREP OF THIS FRAME I OWN MANY OLD PIECES OF EQUIPMENT THAT ARE 30+ YEARS OLDER THAN THIS TRUCK AND NO...

THE DASHBOARD AND HVAC SYSTEM HAS CRACKED TO PIECES CAUSING THE DEFROSTERS TO BE INOPERABLE MOST OF THE TIME AND CONSTANTLY BLOWS PIECES OF PLASTIC AND FOAM OUT OF THE VENTS OCCASIONALLY GETTING IN THE DRIVER'S EYES AND NOSE CAUSING SNEEZING AND DISTRACTING IRRITATION.

THERE IS A ENTRY GRAB HANDLE MOUNTED TO THE INTERIOR DOOR POST NEAR THE WINDSHIELD INTENDED AS AN ASSIST HANDLE. MY TRUCK IS EQUIPPED WITH RUNNING BOARD TO MAKE ENTRY EASIER INTO THE TRUCK CAB. I USED THE ASSIST HANDLE WHILE GETTING INTO THE TRUCK CAB, IT PULLED LOOSE FROM THE PILLAR CAUSING ME TO NEARLY FALL FROM THE TRUCK. I WAS ABLE TO GAIN MY BALANCE AND STEP DOWN FROM THE RUNNING BOARDS WITHOUT DOING ANY INJURY. I AM OF AVERAGE HEIGHT AND WEIGHT APPROPRIATE. WHEN I EXAMINED THE HANDLE I WAS SHOCKED TO SEE THE ONLY MOUNTING INVOLVED WAS PLASTIC WITH A BOLT THROUGH IT SCREWED TO THE DOOR FRAME. THIS IN NO WAY SHOULD BE CLASSIFIED AS AN APPROPRIATE ASSIST HANDLE TO AID ONE IN THE ENTRY OF THE VEHICLE.

DASH AND DEFROSTER GRILL SHATTERED . ONLY 60,000 MILES ON TRUCK THIS SEEMS TO BE A FACTORY DEFAULT AND SHOULD BE REPLACED BY DODGE WITH BETTER MATERIALS. I PURCHASED THIS TRUCK NEW WITH THE 5 YEAR EXTENDED WARRANTY. *TR

I BOUGHT MY 2003 DODGE RAM QUAD CAB 1500 IN JANUARY 2007 WITH ABOUT 38,000 MILES ON IT. AT THE TIME THE PAINT JOB ON THE TRUCK WAS FINE BUT STARTING AROUND APRIL OR MAY THE CLEAR COAT ON THE TRUCK STARTED TO DELAMINATE. I CALLED UP DODGE AND EVEN WENT BY MY LOCAL DODGE DEALER TO COMPLAIN ABOUT THE PAINT JOB BUT I WAS TOLD BECAUSE I'M NOT THE ORIGINAL OWNER AND THAT THE TRUCKS 3 YEAR 36,000 MILE WARRANTY HAS RUN OUT NO ONE WILL FIX MY TRUCK. I'VE BEEN TOLD BY MY LOCAL DODGE DEALER THAT IT IS A FACTORY PROBLEM WITH MY PAINT BUT I'M OUT OF LUCK WHEN IT COMES TO DODGE REPAINTING MY TRUCK. *TR

A-PILLAR-MOUNTED INGRESS HANDLE ON PASSENGER SIDE. I OWN A 2003 RAM 1500 QUAD CAB PICKUP. I BOUGHT THIS TRUCK NEW IN OCTOBER 2003. TODAY, I WAS TRYING TO GET IN THE TRUCK THROUGH THE PASSENGER'S SIDE AND STOOD UP TO TO CLEAN THE WINDSHIELD AND THE A-PILLAR-MOUNTED INGRESS HANDLE CAME OFF. THIS TRUCK HAS 4X4 SO IT IS TALLER THEN THE REGULAR TRUCK. YOU HAVE TO USE THAT HANDLER TO KEEP YOUR BALANCE. LUCKILY ,I DIDN'T GET HURT BECAUSE I USED THE SEAT AND THE DOOR TO AVOIDE FALLING. I CALLED THE DEALERSHIP, AND UNFORTUNATELLY THEY WON'T BE ABLE TO DO ANYTHING TO REPLACE THE A-PILLAR-MOUNTED INGRESS HANDLE BECAUSE THE TRUCK WAS OUT OF WARRANTY. THE TRUCK HAS OVER 60,000 MILES AND I'VE HAD IT 36 MONTHS. MY COMPLAINT WAS WHY DON'T THEY BUILLD THIS HANDLES STRONGER. THEIR PURPOSE WAS TO HELP THE PERSONS GET INTO THE VEHICLES. SHOULDN'T THEY...