1998 DODGE DAKOTA Structureframe And Members Problems

6 NHTSA complaints on file

Check any vehicle history by VIN - Free vehicle history report

Structureframe And Members Issues in the 1998 DODGE DAKOTA

6 structureframe and members complaints have been filed with NHTSA for the 1998 DODGE DAKOTA. Of these, 0 involved a crash, 0 involved a fire, and 0 resulted in injury.

Complaints

Crashes

Fires

Injuries

Deaths

All Structureframe And Members Complaints

#10632123 | September 10, 2014

TL* THE CONTACT OWNS A 1998 DODGE DAKOTA. WHILE DRIVING 45-50 MPH, THE FRAME DETACHED FROM THE VEHICLE WITHOUT WARNING. THE VEHICLE WAS TOWED TO THE CONTACT'S RESIDENCE. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE FAILURE MILEAGE WAS 100,000. UPDATED 10/24/2014*LJ UPDATED 04/20/2015 *JS

#10083079 | August 1, 2004

UPPER AND LOWER BALL JOINTS DETERIORATING 5-24-2004, 27,675 MILES STEERING INTERMEDIATE SHAFT 6-22-2004. BALL JOINTS, LOWER CONTROL ARM, AND RIGHT WHEEL BEARING HAD TO BE REPLACED BY DEALER.*AK STEERING INTERMEDIATE SHAFT HAD TO BE REPLACED AT FREEHOLD DODGE NJ VERY LOOSE FRONT END, HARD TO CONTROL, BOUNCE. TYPICAL SYMPTOMS OF A FRONT END FALLING APART. DATES ABOVE ARE REPLACEMENT DATES. THIRD MAJOR PROBLEM IS ALL OF THE BOLTS ATTACHING THE CAB ARE DETERIORATED. TAKING TO MY NM DODGE DEALER. CAN NOT EVEN TAKE OFF THE BOTS THEY ARE SO BAD ON THE CAB OF MY TRUCK [XXX] I HAVE BEEN THE OWNER FROM DAY ONE. IN MY PARENTS NAME IN NEW JERSEY FOR INSURANCE RATE REDUCTION. UPDATED 07/24/2012* JS INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

#894145 | August 13, 2001

WHILE DRIVING 35 MPH TRACK BAR BROKE OFF THE FRAME. CONSUMER COULD NOT CONTROL VEHICLE. CONTACTED DEALER, AND DEALER GOT 3 ESTIMATES. *AK CONSUMER WAS INFORMED BY A WELDER THAT MANUFACTURER DID NOT PROPERLY WELD BRACKET TO FRAME THE TRACK SUPPORT BAR SUPPORTS THE ENTIRE STEERING ASSEMBLY.*JB

#711891 | September 23, 1999

1. NOISE WHEN RELEASING THE CLUTCH BEGAN DURING A VACATION TRIP IN JUNE 1999, WITH APPROXIMATELY 15,500 MILES ON THE ODOMETER. OVER THE PAST 3 MONTHS THE NOISE HAS BECOME WORSE. THE PROBLEM IS BEING REPAIRED BY THE DEALER WHO SOLD ME THE TRUCK. THEY SAID IT WAS A BEARING IN THE CLUTCH ASSEMBLY. EVEN THOUGH THE WARRANTY FOR THE CLUTCH IS ONLY 1 YEAR THE DEALERSHIP IS FIXING IT FOR ME AT NO CHARGE. 2. THE ORIGINAL CAB ISOLATORS HAD TO BE REPLACED DUE TO THE TRUCK MAKING A LOUD CLUNKING NOISE WHENEVER I TURNED A CORNER OR ENTERED/EXITED A DRIVEWAY. AFTER THE FIRST REPLACEMENT THE CLUNKING STILL OCCURRED SO THE TRUCK WENT BACK IN THE SHOP WHERE THE DEALER "SHAVED" THE ISOLATORS. THAT DIDN'T HELP SO THE TRUCK WENT BACK A THIRD TIME AND ANOTHER SET OF CAB ISOLATORS WERE INSTALLED AND THE CLUNKING SOUND DID NOT OCCUR...

#704928 | March 25, 1999

HAVE NOT BEEN INFORMED OF RECALL CAMPAIGN 98V208000, REGARDING FRAME BOLTS. NO MENTION OF DEFECT UNDER RECALL. *AK

#537400 | October 20, 1998

FRONT WHEEL WELLS HAVE A LARGE GAP BETWEEN WERE THE INNER FENDER ENDS AND THE FRAME STARTS, CAUSING WATER AND SNOW TO BE ABLE TO ENTER ENGINE COMPARTMENT (POTENTIAL SAFETY HAZARD).

Other 1998 DODGE DAKOTA Problem Areas

← Back to 1998 DODGE DAKOTA overview