2007 ALTEC AT40M/P — Problems, Recalls & Safety Data

Check any vehicle history by VIN - Free vehicle history report

N/A

Safety Rating

0

Owner Complaints

1

Recall

ACTIVE RECALL

1

Service Bulletin

0

Investigations

Overview of the 2007 ALTEC AT40M/P

The 2007 ALTEC AT40M/P has received a total of 0 safety complaints filed with the National Highway Traffic Safety Administration (NHTSA). There has been 1 recall campaign affecting this vehicle, covering issues with EQUIPMENT:ELECTRICAL. 1 technical service bulletin have been issued by ALTEC INDUSTRIES INC. for this model year.

Recalls for the 2007 ALTEC AT40M/P

NHTSA has recorded 1 recall for the 2007 ALTEC AT40M/P, potentially affecting up to 103 vehicles.

Recall 11V284000 — EQUIPMENT:ELECTRICAL

| 103 vehicles affected

Defect: ALTEC IS RECALLING CERTAIN AT40M/P AERIAL DEVICES MANUFACTURED FROM JUNE 2007 THROUGH OCTOBER 2009. THESE UNITS HAVE FIBERGLASS ARM LINKS THAT, OVER TIME, MAY DEVELOP REDUCED ELECTRICAL ISOLATION PERFORMANCE. AS SUCH, THE LINKS MAY BEGIN TO CONDUCT CURRENT.

Consequence: IF THE ARM LINK CONDUCTS CURRENT, SHOULD THE ARM LINK CONTACT AN ELECTRICAL WIRE, THE OPERATOR MAY BE SHOCKED OR ELECTROCUTED AND DEATH OR SERIOUS INJURY MAY RESULT.

Remedy: ALTEC WILL REPLACE THE LINK FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 23, 2011. OWNERS MAY CONTACT ALTEC AT 1-877-462-5832.

View full details →

Owner Complaints for the 2007 ALTEC AT40M/P

No complaints have been filed with NHTSA for the 2007 ALTEC AT40M/P.

Safety Rating for the 2007 ALTEC AT40M/P

NHTSA has not yet tested the 2007 ALTEC AT40M/P in its New Car Assessment Program.

Technical Service Bulletins for the 2007 ALTEC AT40M/P

ALTEC INDUSTRIES INC. has issued 1 technical service bulletin (TSBs) for the 2007 ALTEC AT40M/P. TSBs are notices sent by manufacturers to their dealers describing a known issue and the recommended repair procedure.

SIL 777 — ELECTRICAL SYSTEM

Altec has discovered that the fuse for the main contactor in the L JEMS system on the affected units can be undersized. A 250 amp fuse may have been installed instead of the required 400 amp fuse. This can cause repeated blowing of the fuse and resulting loss of power....

NHTSA Investigations for the 2007 ALTEC AT40M/P

There are no NHTSA defect investigations on record for this vehicle.

Other Model Years of the ALTEC AT40M/P

View all ALTEC AT40M/P model years →

Other ALTEC Models

View all ALTEC models →

Check any vehicle history by VIN - Free vehicle history report