NHTSA Complaint #11705851 — 2017 RAM 2500

I am writing to formally demand that Stellantis replace the drag link assembly on my 2017 Ram 2500 at no cost to me. The welding performed during Safety Recall V06 in 2019 has rendered my vehicle unable to receive proper wheel alignment, creating an ongoing safety issue and causing premature tire wear. Background In 2019, my vehicle was brought to dealer to have Safety Recall V06 performed. The recall procedure involved welding the jam nuts to the adjuster sleeve on the drag link. I was not informed at the time that this welding would permanently prevent future alignment adjustments to the drag link. Approximately three months ago, I purchased new tires for my vehicle. When I took my truck to have a wheel alignment performed, I was informed that the alignment cannot be completed because the drag link jam nuts are welded and cannot be adjusted. The alignment is significantly out of specification, causing uneven tire wear and compromised vehicle handling. Current Situation I contacted Hendricks Ram in Cary NC regarding this issue. The dealership has confirmed that: 1.My vehicle cannot be properly aligned due to the welded drag link 2.Ram/Stellantis is refusing to break the welds and replace with the new adjustable drag link kit 3.I am being asked to pay approximately $2,000 out of pocket to correct a problem that was directly caused by Stellantis's recall repair Legal and Regulatory Basis for This Demand October 2023 TSB Update: Stellantis issued revised Technical Service Bulletin instructions for Recall V06 in October 2023 (RCRIT-19V021-0837). This TSB provides that vehicles should be inspected and, depending on conditions found, either have the nuts permanently welded OR the drag link replaced. My vehicle's alignment is out of specification and cannot be corrected—this clearly qualifies for drag link replacement under the revised procedures.