NHTSA Complaint #11696384 — 2019 CHEVROLET SILVERADO 3500

There is a common and very dangerous electrical wire routing problem on my vehicle, along with 3 dozen others and my dads (separate but same truck) i confirmed with (FB group for owners of 17-19 L5P GMC diesel trucks) where the alternator positive wire from the alternator to the battery is run right along and across a rather sharp part of molding from the air intake tube. This routing location and rough intake plastic molding rubs through the alternator wire creating a possible electrical short/ corrosion problems that can lead to battery and electrical system compromise, as well as fire risk! A short-circuit condition can cause damage to engine components and, in rare cases, start a fire in the engine compartment. I have 92,000 miles on this 2019, my father has the problem starting on his at only 40,000 miles and may others have issues as well to very degrees of severity between 25 and 150k miles. I discovered this issue while performing routine air filter maintenance and happened to see the rub damage. no modifications have been done, this is the way the wire is routed from the factory. IMO and estimations This issue far supercedes the danger and severity of the recall that currently exists for the engine block heater cord for these models of trucks. 2 of the photos show the damage and exposed wire as soon as i found it. The last shows the location and the part that caused the rub damage along with a temporary mitigation method: electrical tape with a rubber hose installed as a buffer until a permanent fix can be installed.