NHTSA Complaint #11674846 — 2014 FORD EDGE

7/2/25-i was driving about 20 miles per hour when suddenly my car went into a type of limp/idle mode. It shut the car down to an idle, a wrench light came on my dash then the car started to shake. I coasted into a driveway and turned the car off. I turned it back on after 5min and it was fine. 7/16/25-I was driving about 30mph and all of a sudden my car goes into this idle mode again. I got the car to coast over into a turning lane. It lost power down to an idle, wrench came up on dash again then the car started to shake. I turned the car off and back on and it was fine. I’m very scared to drive my car bc I don’t know when this will happen again. It could be when I’m turning in front of another vehicle, driving on the expressway or just normal streets or if someone was behind me and wasn’t able to react appropriately bc my car goes into this idle mode so fast that I don’t know how to keep from having an accident myself. 7/17/25-I took it to a machanic and they hooked it to a computer but nothing showed up as being wrong. They drove it several times but they couldn’t get it to do what I’m explaining what it does. After researching the issue, I believe it may be my electric throttle body ETB that ford acknowledged was an issue and had a customer satisfaction program CPS (CSP 13N03) from Ford for ETB replacement on certain 2009-2013 ,.* Jels, sometimes extended into the early 2014 model. * Electronic Throttle Body Failure * Ford ETBs from this era are notoriously bad. * Carbon buildup, worn internal sensors, or electronic glitches cause the throttle to stick or respond erratically. * The PCM detects an unsafe throttle position → activates fail-safe mode → wrench light + jerking + no throttle. * You restart the car, and the ETB re-initializes until it fails again.