NHTSA Complaint #11546485 — 2016 JEEP PATRIOT

My Jeep began having a few second stall and restart while driving randomly late 2020. I’m the last 6 months it stalls for longer periods of time but I initially was able to put it in neutral and restart it. About 4 months ago it became more and more difficult to start after I would be forced to pull to the side of the road with no power, hard steering and hard brakes. The check engine light came on at one point. I called the dealership and it was suggested that I take the Jeep in. The diagnostic code indicated the crankshaft position sensor (P0339). But the check engine light wasn’t flashing and it was late in the afternoon so I had to make an appointment to take it back. After 4 days the check engine light went off. The stalling just got very frequent. I would put it in park and turn the ignition repeatedly and after several minutes it would regain power. Just over 1 month ago it stalled in the middle of a busy intersection during afternoon rush hour. It had to be pushed out of the intersection. After more than 10 minutes of continued ignition turns it started and I made it 3 blocks to home and parked it. I had it towed to the same dealership 5 days ago. The crankshaft position sensor has to be replaced. I’ve done research over the last 48 hours and found there was a recall for some 2016 Jeep Patriots for the crankshaft position sensor because it was a safety problem. I’ve checked my VIN number and there has been no recall for this on my vehicle. However, my Jeep Patriot is a 2016 with the exact same problem the the recall was initiated for. Please help me with this if you’re able to. I don’t know where else to turn.