NHTSA Complaint #11505259 — 2019 CHEVROLET EQUINOX

The vehicle is operating on reduced power and shuts of almost immediately. After plugging a scan tool in and reading the codes, it said the crankshaft timing was over advanced and the sensor needed to be changed. I've changed all four sensors (both crank and cam sensors). The engine shows no codes, but when I crank it, it immediately reduces power, shuts off, then shows the same codes. After trying a few times, it says the ECM, MAP sensor, and heat sensors are bad. When I disconnect, then reconnect the battery, it only shows the crank sensor code. The check engine light goes off, but comes on again right before the engine shuts off each time. As a result, the vehicle has been sitting since 10/4/22 due to it shutting off suddenly in traffic. I've had to change the battery twice during this time due to the battery completely dying and a jump start doesn't work.