NHTSA Complaint #11477015 — 2014 FORD FOCUS

01/08/2019- Vehicle was checked for fuel tank deformation (18S32) Vehicle Mileage 65,162 the technician comments read as follows (check dtcs, check for available PCM software update, no available software update, no parts replaced) 07/26/2022- Vehicle was brought to Billy Howell Ford Lincoln Dealership for a permanant emmissions code PO442. Ford Corporate arranged the Diagnostic appointment. The technician comments read as follows (checked dtc's. found multiple DTC's set in various modules. PO442 is only fault set in PCM. checked OASIS, no relevant information found. performed EVAP system test, passed. performed EVAP purge and seal test, passed. connected smoke machine to test for leaks. EVAP smoke machine measured a leak of approxamitely .040", near acceptable range. visual inspection during EVAP leak test, found smoke emitting from vapor canister fresh air vent tube, indicating EVAP vapor canister vent leakage. recommend replacing EVAP vapor canister and retesting. 07/30/2022- I took vehicle to have the EVAP vapor canister replaced mechanic noticed that the fuel tank was slightly deformed. I drove the vehicle approxamitely 120 miles so the PCM would cycle and clear the permanent code . Fuel guage was on empty w/light on. I stopped at gas station I put 26 dollars of e-85 in vehicle. when i returned to car the fuel gauge was reading full DTE 418 miles. The gauge was reading innacurate. I drove the car about 40 miles before it stalled and it would not start. I waited a few minutes and tried to start the vehicle and it started . Iimmediately drove home and parked it in the garage. All of these symptoms point to the recall (18S32) Billy Howell Ford say's my recall was already completed and I cant recall it again. The vehicle has never received a PCM reprogramming for the fuel tank (19S22) Ford was supposed to reprogram the PCM software back in 01/08/2019 when they checked for the tank deformation . Withouty the software update and necessary repairs. its a risk.