NHTSA Complaint #11439587 — 2008 CHRYSLER SEBRING

In February 2021 my car wouldn’t stop, tried to give it a jump and it still wouldn’t start. Replaced the battery and it started working again. In April 2021 my engine light came on. I got a diagnostic and the error code read: P2016 Intake Manifold Runner Position Sensor/Switch Circuit Low Bank 1. I didn’t get it fixed. Shortly after, I began hearing a faint crackling noise and noticed when I would drive on turn pikes my a red brake symbol would briefly pop up on my dash board and then go away. In May 2021 my horn stopped working and front right turn signal light stopped working. I tried to get a new one installed it wouldn’t work. I was told it could be an electrical issue. In July 2021 my right low beam head light stopped working. I tried to get a new bulb installed and it still wouldn’t work. At this time I was told the same thing, that it seems like there may be an electrical issue. This month, November 2021, a few days ago on Monday November 1st, I began noticing an acceleration issue in the morning. I would press the accelerator and it wouldn’t pick up until a few seconds later, it was like a delay. Later that day while I was driving on the free way a red flash symbol with lines between it began flashing on my car and my car wouldn’t drive over 20 mph. I pulled over. Shortly after I turned my car back on and it began driving semi normal and I was able to get home. I tried out my car the next day and in the morning the same thing happened again. The red flash symbol with 2 lines on the side of it began flashing on my dashboard and my car wouldn’t go over 20 mph. I’m not sure what the issue is but when I looked up what the red flashing symbol, I noticed a few others who had a similar experience with their 2008 Chrysler Sebring which made me want to look up whether there was a recall and I found out there was but when I searched whether my car was eligible through my VIN number it said there was none unrepaired.