NHTSA Complaint #11194652 — 2006 CHRYSLER PT CRUISER

NO HEADLIGHT, HIGH BEAM OR LOW BEAM OR TURN SIGNAL RIGHT SIDE. THIS BEGAN ABOUT 6/2017 WHEN REPLACING BULBS DID NOT WORK. A FEW MONTHS LATER THE HORN ALSO STOPPED WORKING. FUEL GAUGE STOPPED READING AND SOMETIMES READS FULL THEN DROPS TOWARD E THEN MAY SHOW HALF. NEVER A CONSTANT READING ANYMORE. ALL FUSES AND RELAYS TEST GOOD. TIPM APPEARS TO BE IN GOOD SHAPE, NO VISIBLE DAMAGE OR DEFECTS TO CIRCUIT BOARDS. NO GOOD VOLTAGE TO HEAD LAMPS OR TURN SIGNAL (METER SHOWS 11.5 VOLTS, BUT APPEARS TO BE A POTENTIAL AND NOT A GOOD VOLTAGE. CANNOT LIGHT A BULB BUT STILL SHOWS THE VOLTAGE ON THE METER), GROUNDS METER GOOD TO CHASSIS. WIRING HARNESS APPEARS GOOD WITH NO INDICATION OF DAMAGE. RUNS VERY ROUGH AND ENGINE LIGHT CODES A CYLINDER 3 MISFIRE. RUNS SMOOTH UNDER ACCELERATION BUT VERY ROUGH ON IDLE AND SOMETIMES STALLS WHEN STOPPING OR AT RED LIGHTS. I HAVE SPENT SEVERAL HUNDRED DOLLARS ALREADY ON TIMING BELTS, ALTERNATORS, INJECTORS AND OTHER MAINTENANCE PROCEDURES. DEALERS WONT LOOK AT IT WITHOUT SEVERAL HUNDRED DOLLARS TO RUN DIAGNOSTICS AGAIN AND AGAIN. I SUSPECT TIPM AND PCM TO BE DEFECTIVE UNITS THROUGHOUT CHRYSLER PRODUCTS. YOU CANNOT DRIVE AT NIGHT BECAUSE I CANT GET THE LIGHTS TO WORK. CAR IS CURRENTLY PARKED BECAUSE IT IS UNUSABLE AND UNSAFE TO DRIVE.