NHTSA Complaint #10637414 — 2013 HONDA PILOT
POWER TRAIN issue reported to NHTSA
Complaint Details
| ODI Number | 10637414 |
| Vehicle | 2013 HONDA PILOT |
| Component | POWER TRAIN |
| Date of Incident | |
| Date Filed | |
| Mileage | 5,500 miles |
| Crash | No |
| Fire | No |
| Injuries | 0 |
| Deaths | 0 |
| Vehicle Towed | No |
| State | FL |
Consumer Description
INTERMITTENTLY WHEN STARTING TO DRIVE AFTER BEING STOPPED AT LIGHT OR STOP SIGN THE ENGINE WILL HESITATE AND BOG DOWN FOR A FEW SECONDS BEFORE IT "KICKS IN" AND THEN THERE IS A "SURGE OF POWER". THIS IS VERY ANNOYING AND ALSO VERY DANGEROUS AS SOMEONE COULD EASILY GET REAR-ENDED OR WORSE YET GET CAUGHT IN THE INTERSECTION IN ONCOMING TRAFFIC. THERE IS ALSO VIBRATION AND SHUTTER AT CERTAIN SPEEDS AND SEEMS TO BE WORST WHEN ECO MODE KICKS IN AND WHEN DRIVING CONSERVATIVELY. THERE IS ALSO A PULL IN THE STEERING UPON ACCELERATION. *TR
Related Complaints for the 2013 HONDA PILOT
Other POWER TRAIN Complaints
#11710068
Repeatedly there has been a cylinder 1 misfire causing the check engine light to activate. The vehicle starts to shak...
#11625394
The lights(traction control light, check engine,) in the dash come on and go off intermittently and vehicle display r...
#11511430
Excessive vibration, speeds above 50mph vibrates the entire vehicle.
#11439632
Since purchasing new in 2013, experienced ongoing issues with VCM. Noticable vibration/shudder at all speeds except d...
#11281056
I CHANGED TIRE ,BUSHING STABILIZER,WHEEL BALANCE ALIGNMENT, CHANGED THE TIE ROD AND CV AXLE BUT THE CAR STILL SHAKING...
Recent Complaints for the 2013 HONDA PILOT
#11710068
ENGINE
Repeatedly there has been a cylinder 1 misfire causing the check engine light to activate. The vehicle starts to shak...
#11710068
SERVICE BRAKES
Repeatedly there has been a cylinder 1 misfire causing the check engine light to activate. The vehicle starts to shak...
#11682551
AIR BAGS
• The side airbags on the passenger side, extending from the front passenger seat to the back, deployed without cause...
#11672818
UNKNOWN OR OTHER
Vcm2 light appearing causing bank 2 to stop working, vibration and rpm not being able to go above 3000 or 5000