NHTSA Complaint #10447662 — 2003 DODGE RAM 2500

I DRIVE TO WORK ON A HIGHWAY 5 DAYS A WEEK AND STARTED TO HAVE LOTS OF VIBRATION AND IT ONLY OCCURRED AT HIGHER SPEEDS AND WOULD CLUNK. TURNS OUT BOTH U-JOINTS FOR THE REAR DRIVE-SHAFT HAD STARTED TO FAIL AND WERE ALLOWING UNWANTED MOVEMENT. AFTER REPLACING THE U-JOINTS THE TRUCK WAS FINE FOR A FEW WEEKS THEN I HEARD SQUEALING OF METAL ON METAL CONTACT AND THERE WAS A SLIGHT WOBBLE. TOOK IT TO A SHOP AND THEY SAID THE HUB BEARINGS WERE SHOT AND WERE MOVING SO MUCH AS TO ALLOW THE WHEEL TO MOVE. AFTER REPLACING THE BEARINGS THE TRUCK WAS FINE FOR ABOUT A MONTH THEN THE WOBBLE WAS BACK AND THE TIE-RODS FOR THE STEERING LINKAGE WERE BAD, SO REPLACED THE STEERING LINKAGE WITH DODGES NEW SETUP SINCE IT WAS HARD TO FIND THE ORIGINAL ONE THAT CAME ON MINE SINCE THERE IS A RECALL ON IT. WITH THE NEW STEERING LINKAGE I GOT IT ALIGNED AND IT WAS GOOD FOR A WEEK AND DROVE STRAIGHT AND NO PROBLEMS. THEN I HIT A POTHOLE AT 55MPH WHILE GOING TO WORK AND I GOT MASSIVE WOBBLE IN THE STEERING SO MUCH SO THAT THE STEERING WHEEL WAS TRYING TO GO BACK AND FORTH AND I HAD TO FIGHT TO KEEP IT ON THE ROAD AND SLOW DOWN ENOUGH TO PULL IT OVER. I LIMPED THE TRUCK TO A SHOP AND THERE WAS NOW LOTS OF PLAY IN THE STEERING AND I COULD MOVE THE WHEEL 3+ INCHES BEFORE GETTING THE WHEEL TO MOVE. THE SHOP REPLACED THE STEERING GEARBOX SINCE THE INPUT SHAFT WOULD MOVE BUT THE OUTPUT WOULD HARDLY MOVE AT ALL. HAD IT ALIGNED AGAIN AND IT STILL CAN NOT BE DRIVEN OVER 35+MPH OR IT GETS MASSIVE WOBBLE. EVERYTHING CHECKS OUT WITH THE STEERING COMPONENTS AND TIRES SINCE EVERYTHING IS ALMOST NEW TO TRY AND SOLVE THIS RECURRING PROBLEM, AND I HAVE SPENT $4578 IN PARTS AND LABOR TO TRY AND SOLVE THIS NEVER ENDING PROBLEM. THE LATEST PROBLEM IS THAT THE HVAC DOES NOT WORK. IT SEEMS THE DOORS CONTROLLING THE TEMP ARE NOT WORKING SINCE THE AC WORKS SPORADICALLY,THE DEFROST HEATS MY FEET, AND WINDOWS STAY FOGGY. *TR