1990 OLDSMOBILE CUTLASS SUPREME Structure Problems

I HAVE A 1990 OLDSMOBLE CUTLASS SUPREME. A RECALL #00065 FOR GM WAS DONE ON MY CAR AND ONLY THE FRONT CRADLE BOLTS AND RETAINERS WERE DONE. BUT UPON REVIEWING NHTSA'S RECALL #00V189000 THE FRONT AND REAR SHOULD HAVE BEEN DONE. SINCE THE REFUSAL FROM GM THE REAR BOLTS HAVE COME DOWN AND MY ENGINE IS LEANING BACK. I HAVE TALKED TO THE DEALER TWICE AND THE MANUFACTURE GM 3 TIMES AND THEY BOTH SAY THAT THEY ONLY HAVE TO DO THE FRONT CRADLE BOLTS FOR THEIR RECALL AND NOT THE REAR. I ALSO HAVE MY ORIGINAL RECEIPT THAT SAYS ONLY 2 BOLTS AND RETAINERS WERE BOUGHT AND INSTALLED. *NM

LTR FM BRYAN GRANT (NJ) *MR. THE CONSUMER RECEIVED A RECALL NOTICE REGARDING THE REPLACEMENT OF THE FRONT AND REAR FRAME CRADLE BOLTS, THE DEALER ONLY REPLACED THE FRONT FRAME CRADLE BOLTS AND RETAINERS, HOWEVER MONTHS LATER THE ENGINE HAD FALLEN FROM THE VEHICLE, WHICH LEFT THE VEHICLE WITH NO STEERING CAPABILITY AND SUBSEQUENTLY THE VEHICLE HAD TO BE TOWED, THE CONSUMER WAS INFORMED THE REAR FRAME CRADLE BOLTS HAD SEPARATED, WHICH WAS SUPPOSE TO HAVE BEEN REPLACED DURING THE INITIAL RECALL. *JB *CB *JB

THE CONSUMER RECEIVED A NOTIFICATION REGARDING THE REPLACEMENT OF THE FRONT AND REAR CRADLE BOLT RETAINER, HOWEVER THE DEALER ONLY REPLACED THE FRONT CRADLE BOLTS. *AK *JB

NHTSA RECALL 00 V 189 000/MANUFACTURER'S RECALL 00061/65 CONCERNING ENGINE CRADLE BOLT: WHILE BEING SERVICED FOR AN OIL CHANGE, TECHNICIAN INFORMED OF A SEVERE CORROSION AROUND RETAINER BOLTS. DEALER AND MANUFACTURER WERE NOTIFIED, THEY INFORMED CONSUMER THAT THIS VEHICLE WAS NOT COVERED UNDER RECALL DUE TO VIN. *AK *YH

CONSUMER RECEIVED REPAIR KIT SENT FOR RECALL 00V189000. HOWEVER, CONSUMERS COMPLAINT IS THAT BOLTS SENT IN REPAIR KIT ARE NOT "LOCK-TIGHT," AND "BUSHING" THAT BOLT FIT INTO ARE CORRODED. *AK CONSUMER STATES HE TOOK VEHICLE TO DEALER FOR BUSHING RETAINER REPLACEMENT, THEY ADVISED CONSUMER HE WAS RESPONSIBLE FOR REPAIRS AND FRONT ALIGNMENT, CONSUMER BOUGHT THE PARTS AND TOOK VEHICLE TO AN INDEPENDENT MECHANIC, THE MECHANIC THEN SHOWED CONSUMER THERE WAS NOT A LOCK ON ANY BOLTS THAT WERE USED, CONSUMER WAS ADVISED THAT ALIGNMENT COULD NOT BE PERFORMED BECAUSE THE HOLES IN THE CRADLE THAT THE BUSHINGS FIT INTO WERE RUSTED TOO BAD TO HOLD THE BUSHINGS TIGHT AND WOULD NOT HOLD ALIGNMENT, CONSUMER STATES HE IS UNABLE TO DRIVE VEHICLE. *JB

AFTER RECEIVING A RECALL NOTICE FROM MANUFACTURER TOOK VEHICLE TO DEALER FOR CRADLE BOLTS REPLACEMENTS. BUT, AT TIME OF REPLACEMENT CONSUMER FOUND OUT THAT CRADLE WAS RUSTATED. *AK THE FRONT SUB FRAME FAILED. *YH

THE CAR WAS ORIGINALLY PURCHASED IN MY WIFE'S NAME (JUDY LYNN MELIN NOW JUDY LYNN WALDREP). THE MILEAGE LISTED IS APPROXIMATE (CAR IS SITTING AT DEALER). WHILE MY WIFE WAS DRIVING THE CAR THROUGH A BUSY INTERSECTION, THE REAR CRADLE MOUNT DROPPED AND SHE LOST CONTROL OF THE CAR. OTHER CARS WERE SWERVING ALL AROUND HER TO AVOID HER. THROUGH SOME MIRACLE, SHE DID NOT STRIKE ANOTHER CAR OR ANY OBJECT; THE CAR ROLLED TO SAFETY, BUT MY WIFE WAS VERY SHAKEN. WE FOUND OUT THAT FOR THIS VERY TYPE OF CAR, IN OTHER STATES, GM/OLDSMOBILE DID A RECALL (97016) IN SEVERAL STATES, BUT NOT OURS (MINNESOTA). WE HAVE HEARD LOCAL MEDIA REPORTS ABOUT THIS PROBLEM OCCURRING IN MN, AND THE STATE ATTORNEY GENERAL'S OFFICE IS INVOLVED. WE HAVE CALLED OLDSMOBILE AND SPOKEN WITH THE DEALER. NEITHER, AT THIS POINT, ARE WILLING TO HELP US. WE JUST WANT TO RECOUP...