2018 NISSAN LEAF — Problems, Recalls & Safety Data

This vehicle is equipped with a feature known as "e-pedal" also known as one-pedal driving which is quite common on EVs. When this mode is activated, the accelerator pedal acts as a speed command (vs. power) and when the pedal is not depressed, the vehicle applies brakes until it comes to a standstill. Recently, the system has demonstrated a fault condition, where the Vehicle Control Module (VCM) issues a fault warning and disengages the e-pedal mode. This appears to occur randomly after the vehicle has been at a standstill for over one minute (e.g. waiting at a traffic signal) where the driver is using the one-pedal system vs. continuously applying pressure to the brake pedal. The safety issue is that when the system detects a fault and disengages e-pedal, the vehicle starts to move forward, requiring the driver to take immediate action to stop unwanted motion. This can lead to a collision with a vehicle or pedestrian in front of the vehicle. The desired behavior is that when the VCM detects a fault with the e-pedal system, it should engage the Park mode and prevent the vehicle from moving forward. The driver must then depress the brake pedal and affirmatively command the Drive mode before moving. Just disengaging the e-pedal (brake) without prior warning of a fault is a safety hazard.

This vehicle is equipped with a feature known as "e-pedal" also known as one-pedal driving which is quite common on EVs. When this mode is activated, the accelerator pedal acts as a speed command (vs. power) and when the pedal is not depressed, the vehicle applies brakes until it comes to a standstill. Recently, the system has demonstrated a fault condition, where the Vehicle Control Module (VCM) issues a fault warning and disengages the e-pedal mode. This appears to occur randomly after the vehicle has been at a standstill for over one minute (e.g. waiting at a traffic signal) where the driver is using the one-pedal system vs. continuously applying pressure to the brake pedal. The safety issue is that when the system detects a fault and disengages e-pedal, the vehicle starts to move forward, requiring the driver to take immediate action to stop unwanted motion. This can lead to a collision with a vehicle or pedestrian in front of the vehicle. The desired behavior is that when the VCM detects a fault with the e-pedal system, it should engage the Park mode and prevent the vehicle from moving forward. The driver must then depress the brake pedal and affirmatively command the Drive mode before moving. Just disengaging the e-pedal (brake) without prior warning of a fault is a safety hazard.

On 1/6/2026, as I slowed down as I was turning into my parking lot. I had Eco and e-pedal ON for regenerative braking. As I was turning into the parking lot, the car suddenly accelerated, went over the curb, across the street, over another curb before finally stopping after colliding with a structure. I was driving slowly and distinctively recall braking. This sudden unintended acceleration put safety at risk and caused significant property damage. There were no warning signs or messages. The car is in the yard now and will be available for inspection.

I was traveling north on Freeway 57 at approximately 70mph. The dash lit up red with 12v and charging warnings. Power was shut off and car went into Neutral and warned me to pull over. This is an incredibly busy freeway and I was in the far left lane. I barely made it to the shoulder coasting before car started shuttering and jerking and stopped rolling. I could have been killed.

I was traveling north on Freeway 57 at approximately 70mph. The dash lit up red with 12v and charging warnings. Power was shut off and car went into Neutral and warned me to pull over. This is an incredibly busy freeway and I was in the far left lane. I barely made it to the shoulder coasting before car started shuttering and jerking and stopped rolling. I could have been killed.