1991 MACK CH — Problems, Recalls & Safety Data

Recall 00V019003 — TRAILER HITCHES:FIFTH WHEEL ASSEMBLY

June 22, 2000 | 90 vehicles affected

Defect: VEHICLE DESCRIPTION: HEAVY DUTY CLASS 8 TRUCKS EQUIPPED WITH FONTAINE FIFTH WHEEL ASSEMBLIES. THE FIFTH WHEEL MOUNTING PLATES CAN CRACK.

Consequence: UNDER THE TRAILER LOADING, THE MOUNTING PLATE COULD EVENTUALLY FAIL DUE TO FATIGUE.

Remedy: DEALERS WILL INSPECT AND REPLACE THE MOUNTING PLATES THAT ARE CRACKED.

View full details →

Recall 94V216000 — POWER TRAIN:DRIVELINE:CENTER SUPPORT BEARING

April 3, 1995 | 17,720 vehicles affected

Defect: THE DRIVESHAFT CENTER BEARING SUPPORT BRACKET CAN CRACK AND BREAK.

Consequence: IF THIS HAPPENS, THE DRIVESHAFT WILL WOBBLE AND CAN SEPARATE. SEPARATION CAN RESULT IN DAMAGE TO OTHER COMPONENTS OF THE VEHICLE OR LOOSE FRAGMENTS CAN FALL ONTO THE ROADWAY PRESENTING A HAZARD TO OTHER DRIVERS.

Remedy: DEALERS WILL REPLACE THE CENTER BEARING HANGER BRACKET.

View full details →

Recall 94V032000 — VEHICLE SPEED CONTROL

May 27, 1994 | 39,777 vehicles affected

Defect: FUEL INJECTION SYSTEM RECONFIGURATION TO COMPLY WITH ENGINE EMISSION STANDARDS CAUSE HIGHER ENGINE VIBRATION LEVELS WHICH LEAD TO EARLY WEAR AND COMPLETE FAILURE OF THE SECONDARY THROTTLE RETURN MECHANISM.

Consequence: IN THE EVENT THE PRIMARY THROTTLE RETURN FAILS, FAILURE OF THE SECONDARY THROTTLE RETURN SYSTEM WOULD NOT PROVIDE PROTECTION AGAINST LOSS OF THROTTLE CONTROL.

Remedy: A NEW PRODUCTION SECONDARY THROTTLE RETURN SYSTEM CONFIGURATION WILL BE INSTALLED.

View full details →

Recall 93V137000 — ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN

October 1, 1993 | 11,000 vehicles affected

Defect: THE ENGINE COOLING FAN BLADES MAY BREAK DUE TO INADEQUATE BLADE STRENGTH AROUND THE RIVETS THAT ATTACH THE BLADES TO THE FAN SPIDER.

Consequence: IF COMPLETE FRACTURE OF THE FAN BLADE OCCURS, IT COULDBE PROPELLED OUTSIDE THE FAN SHROUD, INJURING PERSON(S) IN THE VICINITY OFTHE TRUCK.

Remedy: AN IMPROVED FAN WILL BE INSTALLED ON THESE VEHICLES.

View full details →

Recall 91V112000 — SEAT BELTS:FRONT:ANCHORAGE

October 11, 1991 | 4,000 vehicles affected

Defect: LAP AND SHOULDER SEAT BELT ARRANGEMENT FOR FIXED (NON-SUSPENSION) SEATS DOES NOT MEET THE SEAT BELT LOADING REQUIREMENTS OF FMVSS 210. THE INBOARD CLINCH NUT IN CAB SILL, WHERE THE BUCKLE FOR THE SHOULDER AND LAP BELT IS MOUNTED, PULLED OUT OF THE SILL DURING THE TESTS. CONSEQUENCE OF DEFECT: IF SEAT BELT ANCHIRAGE FAILS, THE SEAT OCCUPANT FACES AN...

Remedy: RELOCATE THE INBOARD SEAT BELT MOUNTING FROM TOP OF THE SILL TO THE FORWARD FLANGE OF THE SILL ON THE CAB FLOOR, AND ADD A 3MM FILLET WELD AROUND THE 2 INBOARD CLINCH NUTS.

View full details →