2001 JEEP WRANGLER Unknown Or Other Problems

FRAME ROTTED BY TRAIL ARMS AND CENTER BY SKID PLATE WHY DID CHRYSLER NEVER RECALL THESE FAULTY FRAMES?

FRAME BEGAN ROTTING OUT AT ROUGHLY 100,000 MILES. I DISCOVERED THIS WHILE DRIVING DOWN THE HIGHWAY ON MY COMMUTE HOME FROM WORK. WHILE ACCELERATING I FELT A SUDDEN POWER LOSS. THIS WENT ON FOR ANOTHER ROUNDTRIP THE FOLLOWING DAY. UPON RETURNING HOME THE FOLLOWING DAY I SAW SOMETHING HANGING FROM UNDERNEATH THE VEHICLE. IT WAS THE SKID PLATE, HANGING BY THE PASSENGER'S SIDE BOLTS, SUPPORTING THE ENTIRE WEIGHT OF THE DRIVETRAIN. THE DRIVESHAFT BEING AT THAT UNNATURAL ANGLE IS WHAT CAUSED THE LOSS OF POWER. TO THINK THAT I HAD DRIVEN 100 MILES THAT WAY WAS SLIGHTLY UNSETTLING. SINCE THEN I HAVE HAD THE FRAME WELDED, WHICH RAN $1,200. I HAVE SINCE HAD THE REAR RAILS (BEHIND REAR WHEELS) REPAIRED FOR AN ADDITIONAL $400. MY FRONT BODY MOUNT HAS ALSO ROTTED OUT, WHICH I FIXED MYSELF FOR $10, BUT SHOULD PROBABLY BE WELDED BY A PROFESSIONAL. BOTH MECHANIC AND WELDER...

SPONTANEOUS VEHICLE FIRE WHILE PARKED FOR TWO WEEKS

THE FRAME ROTTED OUT WHERE THE SUSPENSION CONNECT TO THE FRAME

FRAME ROTTING FROM INSIDE OUT.THIS IS A SEVERE SAFETY CONCERN.THIS IS A PROBLEM RELATED TO CERTAIN YEARS OF WRANGLERS. THE SEVERITY OF THE PROBLEM SHOULD RESULT IN A RECALL AS HAS BEEN WITH OTHER MANUFACTURERS WITH SAME PROBLEM TO RESOLVE THIS VERY UNSAFE CONDITION.

THIS 2001 JEEP WRANGLER TJ FAILED NY STATE SAFETY INSPECTION DUE TO FRAME RUST. PURCHASED NEW ON 06/01/2001 FROM A JEEP DEALERSHIP IN LINDENHURST, NY AND ONLY HAS 116,097 MILES ON A 4.0 ENGINE. THIS TUBULAR FRAME RUST IS PREMATURE DUE TO LACK OF "WEEP HOLES" THAT ALLOWS WATER TO EXIT THE FRAME, THEREBY PROMOTING RUST FROM THE INSIDE, OUT AND IS COSTLY TO REPAIR (SEE ATTACHMENT). NOTE... TOYOTA HAS HAD SIMILAR "RUSTY FRAME" ISSUES, BUT TOYOTA HAS DONE THE "RIGHT THING". SEE WRITE-UP AND VIDEO HERE: HTTP://AUTOWEEK.COM/ARTICLE/RECALLS/TOYOTA-FRAME-SETTLEMENT-COULD-COST-COMPANY-34-BILLION ... I LOVE MY WRANGLER, BUT IF JEEP REFUSES TO HELP WITH THIS (WIDE SPREAD) RUSTY FRAME ISSUE, I MAY VERY WELL MAKE A TOYOTA MY NEXT PURCHASE! THIS IS NOT JUST A CUSTOMER SERVICE ISSUE, THIS IS A BIG SAFETY ISSUE!!!

TAKATA RECALL MY VEHICLE WAS IN MOTION TRAVELING ABOUT 50 MPH WHEN IT LOST CONTROL ON A WET ROAD. THE CAR SLID ACROSS THE ROAD, OVER A SMALL DITCH, AND HEAD ON INTO A TREE. THE CAR BOUNCED FROM THE TREE AND SWIPED THE DRIVERS SIDE WITH ANOTHER TREE AND FINALLY BOUNCING BACK TOWARDS THE ROAD. THE ROAD WAS SLIGHTLY CURVED DOWNHILL IN A SMALL TOWN. I ATTEMPTED TO USE MY BRAKES WHILE OUT OF CONTROL BUT THEY WERE INEFFECTIVE. THE WEATHER CONDITIONS WERE THUNDERSTORMS ON AND OFF, RAINING IN THE AREA OF THE ACCIDENT. I BELIEVE THE AIRBAG IS THE SAFETY RISK. THE CAR HIT THE TREE IN THE CENTER OF THE GRILL WHICH CRACKED THE RADIATOR, TWISTED THE MOTOR MOUNTS, DAMAGED THE SUSPENSION, FOLDED THE FRAME AND SEVERAL OTHER FRACTURES. THE AIRBAG NEVER DEPLOYED, BOTH A BODY SHOP AND THE TOWING COMPANY SAID IT SHOULD HAVE DEPLOYED. THE...

MY 2001 JEEP IS IN REAL GOOD SHAPE VISIBLY AND NO RUST ANYWHERE I CAN TELL ON THE BODY OR OUTSIDE OF THE FRAME. HOWEVER, WHEN PULLING THE CROSSMEMBER OFF THAT HOLDS THE TRANSMISSION/TRANSFER CASE TO THE FRAME, I NOTICED A MASSIVE AMOUNT OF RUST IN THE FRAME. IT LOOKS AS IF THE FRAME CAME OUT OF A 1920 MODEL CAR OR WORSE UNDER THERE. I MAY ATTEMPT TO HAVE THAT SECTION FIXED, BUT I HAVE NOTICED THE BOXED FRAME ON THE JEEP HAS NO WHERE FOR WATER TO GO ONCE INSIDE OF IT. MY ONLY OPTION WOULD BE TO MAKE DRAINAGE HOLES FOR WATER AND TRY TO SPRAY COSMOLINE OR SOMETHING INSIDE THE FRAME AND JUST "HOPE" THE REST OF THE FRAME IS NOT ROTTING FROM THE INSIDE OUT. I WOULD NOT EVEN COMPLAIN BUT A VEHICLE THAT IS BARELY 15 YEARS OLD ALREADY RUSTED OUT THIS BAD ON...

FRAME IS RUSTING DUE TO LACK OF ENGINEERING AND ABSENCE OF DRAIN HOLES IN PROPER LOCATIONS. INSIDE OF FRAME IS FLAKING OFF AROUND CONTROL ARM FRAME MOUNTS FRONT AND BACK. JEEP IS GARAGE KEPT AND TAKEN CARE OF. WATER POOLS UP AND HAS NO WHERE TO GO SO A HOLE HAS RUST THROUGH PASSENGER SIDE FRONT BEHIND CONTROL ARM MOUNT. LOTS OF FLAKING OFF FROM INSIDE OF FRAME. INCREDIBLY BAD PLANNING ON MANUFACTURER'S PART AND NOW I HAVE A POTENTIALLY UNSAFE VEHICLE TO DRIVE WITHOUT SOME MAJOR FRAME WORK TO PERFORM. TOYOTA TRUCKS HAD A SIMILAR ISSUE AND THEY REPLACED THE FRAME.

FRAME IS RUSTING FROM THE INSIDE OUT. THERE ARE SPOTS IN THE FRAME WHERE PARTS ARE NOW MISSING, CREATING HOLES AND WEAKENING THE FRAME AS A WHOLE. THERE ARE NO ADEQUATE DRAIN HOLES IN THE FRAME, FROM THE FACTORY, TO ALLOW WATER TO DRAIN FROM THE FRAME. THIS HAS HAPPENED OVER TIME.

FRAME RUSTED OUT AND TRANSMISSION WAS HANGING UNDER VEHICLE. FURTHER INSPECTION AND THE FRAME IS ROTTED AT REAR SUSPENSION MOUNTS. CHECKING ON WRANGLER FORUMS AND MANY PEOPLE ARE HAVING THE SAME FRAME ISSUES. I'D HATE TO SEE WHAT WOULD HAPPEN WHEN ONE OF THE REAR FRAME PIECES LETS GO WHILE SOMEONE IS GOING DOWN THE HIGHWAY. *TT

VEHICLE WAS PURCHASED ON NUNE 25, AND ENGINE LIGHT CAME ON ON JUNE 26. TOOK VEHICLE TO DEALER, AND THEY SAID IT WAS A CATALYTIC CONVERTER PROBLEM, CONSUMER STATED THAT ON JUNE 28, ENGINE LIGHT CAME BACK ON. *AK