1979 FORD THUNDERBIRD — Problems, Recalls & Safety Data

Recall 08E019000 — FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP

March 19, 2008 | 1,937 vehicles affected

Defect: INTERCONTINENTAL AUTO PARTS IS RECALLING 1,937 FUEL FILTERS, P/NOS ALG 44/1 AND PUROLATOR F10024, SHIPPED BETWEEN JANUARY 14 AND FEBRUARY 13, 2008, SOLD FOR USE ON THE VEHICLES LISTED ABOVE. THE FILTER'S OUTLET CAP MAY NOT BE SECURELY CRIMPED TO THE HOUSING. THIS COULD RESULT IN A SEPARATION OF FILTER'S OUTLET CAP FROM THE HOUSING.

Consequence: IF THIS CONDITION OCCURS WHILE ATTEMPTING TO START THE VEHICLE, A NO START CONDITION MAY RESULT AND FUEL MAY BE PUMPED ONTO THE GROUND. IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION, THE ENGINE MAY STOP DUE TO INADEQUATE FUEL SUPPLY. IF AN IGNITION SOURCE WERE PRESENT, FUEL LEAKAGE MAY RESULT IN A FIRE.

Remedy: INTERCONTINENTAL WILL REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING MARCH 2008. OWNERS MAY CONTACT INTERCONTINENTAL AT 800-451-2593.

Recall 79V117000 — SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES

June 18, 1979 | 82,000 vehicles affected

Defect: THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.

Remedy: DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.

Recall 79V013000 — SEATS:MID/REAR ASSEMBLY

March 20, 1979 | 4,000 vehicles affected

Defect: THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH INCORRECT WELD NUTS THAT ATTACH THE REAR PORTION OF THE FRONT OUTBOARD SEAT TRACK TO THE FLOOR PAN. THE INCORRECT NUTS HAVE AN OVERSIZE DIAMETER AND THREAD, AND UPON FRONT SEAT TRACK ANCHOR BOLT INSTALLATION, THE THREADS MAY HAVE BEEN STRIPPED.

Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, REPAIR ANY STRIPPED WELD NUTS AND INSTALL LARGER SIZE BOLTS TO ANCHOR THE SEAT TRACK TO THE FLOOR AT NO COST TO OWNER.

Recall 78V269000 — STEERING:GEAR BOX:SHAFT SECTOR

December 12, 1978 | 20,000 vehicles affected

Defect: THE STEERING GEARS ON THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH IMPROPERLY MANUFACTURED SECTOR SHAFTS FROM WHICH THE THREADED PORTIONS OF THE SHAFTS MAY FRACTURE AND SEPARATE. SHOULD THE SECTOR SHAFT FRACTURE, THE PITMAN ARM MAY DISENGAGE FROM THE SPLINED PORTION OF THE SECTOR SHAFT.

Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE STEERING GEAR ASSEMBLY OR INSTALL A NEW SECTOR SHAFT IN THE STEERING GEAR ASSEMBLY.